MCF5253CVM140 Freescale Semiconductor, MCF5253CVM140 Datasheet - Page 199

• Manufacturer Part Number: MCF5253CVM140
• Description: IC MPU 32BIT 140MHZ 225-MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: MCF525xr

Specifications of MCF5253CVM140

• Core Processor: Coldfire V2
• Core Size: 32-Bit
• Speed: 140MHz
• Connectivity: CAN, EBI/EMI, I²C, QSPI, UART/USART, USB OTG
• Peripherals: DMA, WDT
• Program Memory Type: ROMless
• Ram Size: 128K x 8
• Voltage - Supply (vcc/vdd): 1.08 V ~ 1.32 V
• Data Converters: A/D 6x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 225-MAPBGA
• Family Name: MCF5xxx
• Device Core: ColdFire V2
• Device Core Size: 32b
• Frequency (max): 140MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.2/3.3V
• Operating Supply Voltage (max): 1.32/3.6V
• Operating Supply Voltage (min): 1.08/3V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 225
• Package Type: MA-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of I /o: -
• Eeprom Size: -
• Program Memory Size: -
• Lead Free Status / Rohs Status: Compliant

Chapter 13
IDE and Flash Media Interface
This chapter describes the operation of the bus interface to IDE and Flash Media, the interface setup,
timing and operation are provided as well as commonly used commands.
13.1
The MCF5253 memory bus allows connection of an IDE hard disk drive or SmartMedia flash card with a
minimum of external hardware.
illustrates an interface with both an IDE device and a SmartMedia device connected although both cannot
be supported simultaneously as the IDE_DIOR and IDE_DIOW signals can only be used to interface to
one or the other.
Freescale Semiconductor
IDE and SmartMedia Overview
SmartMedia refers to Flash memory cards such as Compact Flash. For other
Flash Media such as Secure Digital (SD), MultiMedia Card (MMC) or
Memory Stick, refer to
For support as a Flash Media Interface, this solution is recommended.
This IDE and Flash Media Interface is not recommended for new IDE
designs. All new IDE designs should use the ATA Interface, refer to
Chapter 22, “USB, ATA DMA, and Clock Integration
drive IDE designs may still be supported through this legacy IDE Interface.
Figure 13-1
MCF5253 Reference Manual, Rev. 1
Section 13.4, “Flash Media Interface.”
shows the bus set-up for the MCF5253 device. The figure
NOTE
Module”. Older hard
13-1