R5S72011 RENESAS [Renesas Technology Corp], R5S72011 Datasheet - Page 376

• Manufacturer Part Number: R5S72011
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 11 Direct Memory Access Controller (DMAC)
11.4.3
(1)
Initial settings must be made in each of the relevant registers before the DMA transfer enable bit is
set (DEN = "1"). These settings cannot be changed once transfer has started.
An example of DMAC registers that require initial settings is given below.
1. DMA mode register (DMMODn)
2. DMA control register A (DMCNTAn)
3. DMA control register B (DMCNTBn)
4. DMA current source address register (DMCSADRn)
5. DMA reload source address register (DMRSADRn)  when the reload function is used
6. DMA current destination address register (DMCDADRn)
7. DMA reload destination address register (DMRDADRn)  when the reload function is used
8. DMA current byte count register (DMCBCTn)
9. DMA reload byte count register (DMRBCTn)  when the reload function is used
10. DMA interrupt control register (DMICNT)  when an interrupt is used
11. DMA common interrupt control register (DMICNTA)  when an interrupt is used
12. DMA transfer enable bit (DEN)
13. DMA activation control register (DMSCNT)
(2)
DMA transfer for a channel is enabled by setting the DMA transfer enable bit (DEN) in DMA
control register B for the channel and the DMAC module activation bit (DMST) in the DMAC
activation register (DMSCNT) to "1".
When multiple DMA transfer requests are present, there is no complex mechanism for the
determination of channel priority. The DMA request that corresponds to the highest priority
channel is simply accepted and DMA transfer on that channel starts.
Whether a DMA request on a given channel is or is not present can be verified by testing the value
of the DMA request bit (DREQ) in DMA control register B (DMCNTBn) for that channel.
When a DMA request is accepted and DMA transfer starts, the DMA arbitration status bit
(DASTS) for the corresponding channel in the DMA arbitration status register (DMASTS) is set
to "1".
Rev. 2.00 Sep. 07, 2007 Page 348 of 1164
REJ09B0321-0200
Initial Settings of the DMAC
DMA Activation
DMA Activation