R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 976

Manufacturer Part Number

R0K572030S000BE

KIT DEV FOR SH7203

Manufacturer

Renesas Electronics America

Renesas Starter Kits (RSK)r

CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM

Silicon Manufacturer

Kit Contents

Silicon Family Name

Silicon Core Number

R5S72030W200FP

Tool / Board Applications

General Purpose MCU, MPU, DSP, DSC

Mcu Supported Families

Lead Free Status / RoHS Status

Contains lead / RoHS non-compliant

For Use With/related Products

Lead Free Status / Rohs Status

Section 19 Controller Area Network (RCAN-TL1)

Bit 4 — Halt/Sleep Status Bit (GSR4): Indicates whether the CAN engine is in the halt/sleep

state or not. Please note that the clearing time of this flag is not the same as the setting time of

Please note that this flag reflects the status of the CAN engine and not of the full RCAN-TL1 IP.

RCAN-TL1 exits sleep mode and can be accessed once MCR5 is cleared. The CAN engine exits

sleep mode only after two additional transmission clocks on the CAN Bus.

Bit 3 — Reset Status Bit (GSR3): Indicates whether the RCAN-TL1 is in the reset state or not.

Rev. 3.00 Sep. 28, 2009 Page 944 of 1650

REJ09B0313-0300

RCAN-TL1 is not in Error Passive or in Bus Off status (Initial value)

[Reset condition] RCAN-TL1 is in Error Active state

RCAN-TL1 is in Error Passive (if GSR0 = 0) or Bus Off (if GSR0 = 1)

[Setting condition] When TEC ≥ 128 or REC ≥ 128 or if Error Passive Test

Mode is selected

RCAN-TL1 is not in the Halt state or Sleep state (Initial value)

Halt mode (if MCR1 = 1) or Sleep mode (if MCR5 = 1)

[Setting condition] If MCR1 is set and the CAN bus is either in intermission or

idle or MCR5 is set and RCAN-TL1 is in the halt mode or RCAN-TL1 is

moving to Bus Off when MCR14 and MCR6 are both set

RCAN-TL1 is not in the reset state

Reset state (Initial value)

[Setting condition] After an RCAN-TL1 internal reset (due to SW or HW