R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 1226

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

Section 23 USB 2.0 Host/Function Module (USB)
• When the function controller function has been selected and the response PID is set by
(5)
• The ISEL bit in CFIFOSEL (applies only when DCP is selected)
• The TGL and SCLR bits in CFIFOSIE
• The DCLRM, TRENB, TRCLR, and DEZPM bits in DnFIFOSEL
• The TRNCNT bit in DxFIFOTRN
• Bits in DCPCFG
• Bit in DCPMAXP
• Bits in DCPCTR (excepting the CCPL bit)
• Bits in PIPECFG
• Bits in PIPEBUF
• Bits in PIPEMAXP
• Bits in PIPEPERI
Rev. 3.00 Sep. 28, 2009 Page 1194 of 1650
REJ09B0313-0300
B. BUF setting: There is no BUF writing by this module.
C. STALL setting: In the following cases, PID = STALL is set and issuing of tokens is
hardware:
A. NAK setting: In the following cases, PID = NAK is set and NAK is always returned in
B. BUF setting: There is no BUF writing by this module.
C. STALL setting: In the following cases, PID = STALL is set and STALL is always returned
Registers that Should Not be Set in the USB Communication Enabled (PID = BUF)
State
• If a short packet is received when the SHTNAK bit in PIPECFG has been set to 1 for
• If the transaction counter ended when the SHTNAK bit has been set to 1 for bulk
automatically stopped:
• When STALL is received in response to the transmitted token.
• When the size of the receive data packet exceeds the maximum packet size.
response to transactions:
• When the SETUP token is received normally (DCP only).
• If the transaction counter ended or a short packet is received when the SHTNAK bit in
in response to transactions:
• When the size of the receive data packet exceeds the maximum packet size.
• When a control transfer sequence error has been detected.
bulk transfer.
transfer.
PIPECFG has been set to 1 for bulk transfer.