R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 664

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

Section 11 Multi-Function Timer Pulse Unit 2 (MTU2)
11.8.4
• When making a transition to a mode (Normal, PWM1, PWM2, PCM) in which the pin output
• In PWM mode 1, since a waveform is not output to the TIOC*B (TIOC *D) pin, setting TIOR
• In PWM mode 2, since a waveform is not output to the cycle register pin, setting TIOR will
• In normal mode or PWM mode 2, if TGRC and TGRD operate as buffer registers, setting
• In PWM mode 1, if either TGRC or TGRD operates as a buffer register, setting TIOR will not
• When making a transition to a mode (CPWM, RPWM) in which the pin output level is
Note: Channel number is substituted for * indicated in this article.
Pin initialization procedures are described below for the numbered combinations in table 11.57.
The active level is assumed to be low.
Rev. 3.00 Sep. 28, 2009 Page 632 of 1650
REJ09B0313-0300
level is selected by the timer I/O control register (TIOR) setting, initialize the pins by means of
a TIOR setting.
will not initialize the pins. If initialization is required, carry it out in normal mode, then switch
to PWM mode 1.
not initialize the pins. If initialization is required, carry it out in normal mode, then switch to
PWM mode 2.
TIOR will not initialize the buffer register pins. If initialization is required, clear buffer mode,
carry out initialization, then set buffer mode again.
initialize the TGRC pin. To initialize the TGRC pin, clear buffer mode, carry out initialization,
then set buffer mode again.
selected by the timer output control register (TOCR) setting, switch to normal mode and
perform initialization with TIOR, then restore TIOR to its initial value, and temporarily disable
channel 3 and 4 output with the timer output master enable register (TOER). Then operate the
unit in accordance with the mode setting procedure (TOCR setting, TMDR setting, TOER
setting).
Overview of Initialization Procedures and Mode Transitions in Case of Error
during Operation, etc.