HD64F3026X25 Renesas Electronics America, HD64F3026X25 Datasheet - Page 404

• Manufacturer Part Number: HD64F3026X25
• Description: MCU 3V 256K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3026X25

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 12 Serial Communication Interface
Bit 3—Multiprocessor Interrupt Enable (MPIE): Enables or disables multiprocessor interrupts.
The MPIE bit setting is valid only in asynchronous mode, and only if the MP bit is set to 1 in
SMR. The MPIE bit setting is ignored in synchronous mode or when the MP bit is cleared to 0.
Bit 3
MPIE
0
1
Note: * The SCI does not transfer receive data from RSR to RDR, does not detect receive errors,
Bit 2—Transmit-End interrupt Enable (TEIE): Enables or disables the transmit-end interrupt
(TEI) requested if TDR does not contain valid transmit data when the MSB is transmitted.
Bit 2
TEIE
0
1
Note: * TEI interrupt requests can be cleared by reading the value 1 from the TDRE flag in SSR,
Bits 1 and 0—Clock Enable 1 and 0 (CKE1, CKE0): The function of these bits differs for the
normal serial communication interface and for the smart card interface. Their function is switched
with the SMIF bit in SCMR.
Rev. 2.00 Sep 20, 2005 page 364 of 800
REJ09B0260-0200
and does not set the RDRF, FER, and ORER flags in SSR. When it receives data in which
MPB = 1, the SCI sets the MPB bit to 1 in SSR, automatically clears the MPIE bit to 0,
enables RXI and ERI interrupts (if the TIE and RIE bits in SCR are set to 1), and allows the
FER and ORER flags to be set.
then clearing the TDRE flag to 0, thereby also clearing the TEND flag to 0; or by clearing
the TEIE bit to 0.
Description
Multiprocessor interrupts are disabled (normal receive operation) (Initial value)
[Clearing conditions]
Multiprocessor interrupts are enabled *
Receive-data-full interrupts (RXI), receive-error interrupts (ERI), and setting of
the RDRF, FER, and ORER status flags in SSR are disabled until data with the
multiprocessor bit set to 1 is received.
Description
Transmit-end interrupt requests (TEI) are disabled *
Transmit-end interrupt requests (TEI) are enabled *
The MPIE bit is cleared to 0
MPB = 1 in received data
(Initial value)