CSM9S12XDT512SLK Freescale Semiconductor, CSM9S12XDT512SLK Datasheet - Page 581

• Manufacturer Part Number: CSM9S12XDT512SLK
• Description: KIT STUDENT LEARNING 16BIT
• Manufacturer: Freescale Semiconductor

Specifications of CSM9S12XDT512SLK

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

1
2
3
Freescale Semiconductor
READ_NEXT
READ_PC
READ_D
READ_X
READ_Y
READ_SP
WRITE_NEXT<f-hel
vetica><st-superscri
pt>
WRITE_PC
WRITE_D
WRITE_X
WRITE_Y
WRITE_SP
GO
GO_UNTIL
TRACE1
TAGGO -> GO
If enabled, ACK will occur when data is ready for transmission for all BDM READ commands and will occur after the write is
complete for all BDM WRITE commands.
are accessed rather than user code. Writing BDM firmware is not possible.
System stop disables the ACK function and ignored commands will not have an ACK-pulse (e.g., CPU in stop or wait mode).
The GO_UNTIL command will not get an Acknowledge if CPU executes the wait or stop instruction before the “UNTIL”
condition (BDM active again) is reached (see
When the firmware command READ_NEXT or WRITE_NEXT is used to access the BDM address space the BDM resources
Command
3
2
1
Opcode
(hex)
0C
62
63
64
65
66
67
42
43
44
45
46
47
08
10
18
16-bit data out Increment X index register by 2 (X = X + 2), then read word X points to.
16-bit data out Read program counter.
16-bit data out Read D accumulator.
16-bit data out Read X index register.
16-bit data out Read Y index register.
16-bit data out Read stack pointer.
16-bit data in
16-bit data in
16-bit data in
16-bit data in
16-bit data in
16-bit data in
Data
none
none
none
none
MC9S12XDP512 Data Sheet, Rev. 2.21
Table 15-6. Firmware Commands
Section 15.4.7, “Serial Interface Hardware Handshake Protocol”
Increment X index register by 2 (X = X + 2), then write word to location
pointed to by X.
Write program counter.
Write D accumulator.
Write X index register.
Write Y index register.
Write stack pointer.
Go to user program. If enabled, ACK will occur when leaving active
background mode.
Go to user program. If enabled, ACK will occur upon returning to active
background mode.
Execute one user instruction then return to active BDM. If enabled,
ACK will occur upon returning to active background mode.
(Previous enable tagging and go to user program.)
This command will be deprecated and should not be used anymore.
Opcode will be executed as a GO command.
Chapter 15 Background Debug Module (S12XBDMV2)
Description
last Note).
581