R5F61525 RENESAS [Renesas Technology Corp], R5F61525 Datasheet - Page 684

• Manufacturer Part Number: R5F61525
• Description: 32-Bit CISC Microcomputer H8SX Family H8SX/1500 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 17 Flash Memory (0.18-(m F-ZTAT Version)
(7)
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
5. After selection of the device and clock mode, inquiries for other required information should
6. A new bit rate should be selected with the new bit-rate selection (H'3F) command, according
7. After selection of the device and clock mode, the information of the user boot MAT and user
8. After making inquiries and selecting a new bit rate, issue the transition to
Rev. 3.00 Mar. 14, 2006 Page 646 of 804
REJ09B0104-0300
with a device-selection (H'10) command.
and set.
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
to the returned information on multiplication ratios and operating frequencies.
MAT should be made to inquire about the user boot MATs information inquiry (H'24), user
MATs information inquiry (H'25), erased block information inquiry (H'26), and programming
unit inquiry (H'27).
programming/erasing state command (H'40). The boot program will then enter the
programming/erasing state.
Command Order