R5F61525 RENESAS [Renesas Technology Corp], R5F61525 Datasheet - Page 460

• Manufacturer Part Number: R5F61525
• Description: 32-Bit CISC Microcomputer H8SX Family H8SX/1500 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 12 Serial Communication Interface (SCI)
12.6
Figure 12.14 shows the general format for clocked synchronous communication. In clocked
synchronous mode, data is transmitted or received in synchronization with clock pulses. One
character in transfer data consists of 8-bit data. In data transmission, the SCI outputs data from one
falling edge of the synchronization clock to the next. In data reception, the SCI receives data in
synchronization with the rising edge of the synchronization clock. After 8-bit data is output, the
transmission line holds the MSB output state. In clocked synchronous mode, no parity bit or
multiprocessor bit is added. Inside the SCI, the transmitter and receiver are independent units,
enabling full-duplex communication by use of a common clock. Both the transmitter and the
receiver also have a double-buffered structure, so that the next transmit data can be written during
transmission or the previous receive data can be read during reception, enabling continuous data
transfer.
12.6.1
Either an internal clock generated by the on-chip baud rate generator or an external
synchronization clock input at the SCK pin can be selected, according to the setting of the CKE1
and CKE0 bits in SCR. When the SCI is operated on an internal clock, the synchronization clock
is output from the SCK pin. Eight synchronization clock pulses are output in the transfer of one
character, and when no transfer is performed the clock is fixed high. Note that in the case of
reception only, the synchronization clock is output until an overrun error occurs or until the RE bit
is cleared to 0.
Rev. 3.00 Mar. 14, 2006 Page 422 of 804
REJ09B0104-0300
Figure 12.14 Data Format in Clocked Synchronous Communication (LSB-First)
Operation in Clocked Synchronous Mode
Clock
Synchronization
clock
Serial data
Note: * Holds a high level except during continuous transfer.
Don't care
*
LSB
Bit 0
One unit of transfer data (character or frame)
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
MSB
Bit 7
Don't care
*