R5F61525 RENESAS [Renesas Technology Corp], R5F61525 Datasheet - Page 647

• Manufacturer Part Number: R5F61525
• Description: 32-Bit CISC Microcomputer H8SX Family H8SX/1500 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

12. Programming is executed. The entry point of the programming program is a the address which
13. The return value in the programming program, the FPFR parameter is determined.
14. Determine whether programming of the necessary data has finished. If more than 128 bytes of
15. After programming finishes, clear FKEY and specify software protection. If this LSI is
is 16 bytes after #DLTOP (start address of the download destination specified by FTDAR).
Call the subroutine to execute programming by using the following steps.
MOV.L
JSR
NOP
 The general registers other than ER0 and ER1 are held in the programming program.
 R0L is a return value of the FPFR parameter.
 Since the stack area is used in the programming program, a stack area of 128 bytes at the
data are to be programmed, update the FMPAR and FMPDR parameters in 128-byte units, and
repeat steps 11 to 14. Increment the programming destination address by 128 bytes and update
the programming data pointer correctly. If an address which has already been programmed is
written to again, not only will a programming error occur, but also flash memory will be
damaged.
restarted by a reset immediately after programming has finished, secure the reset input period
(period of RES = 0) of at least 100 µs.
maximum must be allocated in RAM.
#DLTOP+16,ER2
@ER2
; Set entry address to ER2
; Call programming routine
Section 17 Flash Memory (0.18-(m F-ZTAT Version)
Rev. 3.00 Mar. 14, 2006 Page 609 of 804
REJ09B0104-0300