MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 641

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

1. Address must be 32-bit aligned (two LSBs must be zero).
2. One byte of dummy data must be shifted in before valid data is shifted out.
3. Address must be 64-bit aligned (three LSBs must be zero).
4. A section is defined as half the size of the flash sector size. Total number of data bytes programmed must be a multiple of
5. Bulk Erase is accepted when security is set only if the BEDIS status bit is not set.
6. Note that the Flash will be in NVM Special mode, restricting which types of commands can be executed through
29.3.1 Command Descriptions
This section describes the module commands.
29.3.1.1 Write Enable
The Write Enable command (WREN) sets the write enable register bit in the EzPort
status register. The write enable bit must be set for a write command (SP, SE, BE,
WRFCCOB) to be accepted. The write enable register bit clears on reset, on a Write
Disable command, and at the completion of write command. This command should not
be used if a write is already in progress.
29.3.1.2 Write Disable
The Write Disable command (WRDI) clears the write enable register bit in the status
register. This command should not be used if a write is already in progress.
29.3.1.3 Read Status Register
The Read Status Register command (RDSR) returns the contents of the EzPort status
register.
Freescale Semiconductor, Inc.
FAST_RDFCCOB
8.
WRITE_FCCOB when security is enabled.
WRFCCOB
Command
RESET
Read FCCOB registers at high
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
Write FCCOB Registers
Table 29-2. EzPort Commands (continued)
Description
Reset Chip
speed
Code
0xB9
0xBA
0xBB
Address
Bytes
0
0
0
Data Bytes
1 - 12
12
0
2
Chapter 29 EzPort
Accepted when
secure?
Yes
Yes
No
6
641