MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 467

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

21.5.3.2 Round-robin channel arbitration
Channels are serviced starting with the highest channel number and rotating through to
the lowest channel number without regard to the channel priority levels.
21.5.4 Performing DMA transfers
21.5.4.1 Single request
To perform a simple transfer of n bytes of data with one activation, set the major loop to
one (TCDn_CITER = TCDn_BITER = 1). The data transfer begins after the channel
service request is acknowledged and the channel is selected to execute. After the transfer
is complete, the TCDn_CSR[DONE] bit is set and an interrupt generates if properly
enabled.
For example, the following TCD entry is configured to transfer 16 bytes of data. The
eDMA is programmed for one iteration of the major loop transferring 16 bytes per
iteration. The source memory has a byte wide memory port located at 0x1000. The
destination memory has a 32-bit port located at 0x2000. The address offsets are
programmed in increments to match the transfer size: one byte for the source and four
bytes for the destination. The final source and destination addresses are adjusted to return
to their beginning values.
This generates the following event sequence:
Freescale Semiconductor, Inc.
1. User write to the TCDn_CSR[START] bit requests channel service.
2. The channel is selected by arbitration for servicing.
3. eDMA engine writes: TCDn_CSR[DONE] = 0, TCDn_CSR[START] = 0,
TCDn_CITER = TCDn_BITER = 1
TCDn_NBYTES = 16
TCDn_SADDR = 0x1000
TCDn_SOFF = 1
TCDn_ATTR[SSIZE] = 0
TCDn_SLAST = -16
TCDn_DADDR = 0x2000
TCDn_DOFF = 4
TCDn_ATTR[DSIZE] = 2
TCDn_DLAST_SGA= –16
TCDn_CSR[INT_MAJ] = 1
TCDn_CSR[START] = 1 (Should be written last after all other fields have been initialized)
All other TCDn fields = 0
TCDn_CSR[ACTIVE] = 1.
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
Chapter 21 Direct Memory Access Controller (eDMA)
467