MK30DN512ZVLK10 Freescale Semiconductor, MK30DN512ZVLK10 Datasheet - Page 617

• Manufacturer Part Number: MK30DN512ZVLK10
• Description: ARM Microcontrollers - MCU KINETIS 512K SLCD
• Manufacturer: Freescale Semiconductor

Specifications of MK30DN512ZVLK10

• Core: ARM Cortex M4
• Processor Series: K30
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 128 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-80
• Mounting Style: SMD/SMT

28.4.10.5 Program Longword Command
The Program Longword command programs four previously-erased bytes in the program
flash memory using an embedded algorithm.
1. Must be longword aligned (Flash address [1:0] = 00).
Upon clearing CCIF to launch the Program Longword command, the FTFL programs the
data bytes into the flash using the supplied address. The swap indicator address in each
program flash block is implicitly protected from programming. The targeted flash
locations must be currently unprotected (see the description of the FPROT registers) to
permit execution of the Program Longword operation.
The programming operation is unidirectional. It can only move NVM bits from the erased
state ('1') to the programmed state ('0'). Erased bits that fail to program to the '0' state are
flagged as errors in MGSTAT0. The CCIF flag is set after the Program Longword
operation completes.
Freescale Semiconductor, Inc.
Flash address is out-of-range for the targeted resource.
Flash address is not longword aligned
Error Condition
FCCOB Number
0
1
2
3
4
5
6
7
Table 28-38. Read Resource Command Error Handling (continued)
Table 28-39. Program Longword Command FCCOB Requirements
A Flash memory location must be in the erased state before
being programmed. Cumulative programming of bits (back-to-
back program operations without an intervening erase) within a
Flash memory location is not allowed. Re-programming of
existing 0s to 0 is not allowed as this overstresses the device.
K30 Sub-Family Reference Manual, Rev. 6, Nov 2011
CAUTION
FCCOB Contents [7:0]
Flash address [23:16]
Byte 0 program value
Byte 1 program value
Byte 2 program value
Byte 3 program value
Flash address [15:8]
Flash address [7:0]
0x06 (PGM4)
Chapter 28 Flash Memory Module (FTFL)
1
FSTAT[ACCERR]
FSTAT[ACCERR]
Error Bit
617