HD6417727F100CV Renesas Electronics America, HD6417727F100CV Datasheet - Page 607

• Manufacturer Part Number: HD6417727F100CV
• Description: SH3-DSP, LEAD FREE
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417727F100CV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 100MHz
• Connectivity: FIFO, SCI, SIO, SmartCard, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 104
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.6 V ~ 2.05 V
• Data Converters: A/D 6x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 240-QFP Exposed Pad, 240-eQFP, 240-HQFP
• Cpu Family: SuperH
• Device Core Size: 32b
• Frequency (max): 100MHz
• Interface Type: SCI/USB
• Program Memory Size: Not Required
• Total Internal Ram Size: 16KB
• # I/os (max): 104
• Number Of Timers - General Purpose: 4
• Operating Supply Voltage (typ): 1.8/3.3V
• Operating Supply Voltage (max): 2.05/3.6V
• Operating Supply Voltage (min): 1.6/2.6V
• On-chip Adc: 6-chx10-bit
• On-chip Dac: 2-chx8-bit
• Instruction Set Architecture: RISC
• Operating Temp Range: -20C to 75C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 240
• Package Type: HQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Lead Free Status / Rohs Status: Compliant

18.3.2
Figure 18.2 shows the pin connection diagram for the smart card interface. During communication
with an IC card, transmission and reception are both carried out over the same data transfer line,
so connect the TxD0 and RxD0 pins on the chip. Pull up the data transfer line to the power supply
V
When using the clock generated by the smart card interface on an IC card, input the SCK0 pin
output to the IC card’s CLK pin. This connection is not necessary when the internal clock is used
on the IC card.
Use the chip’s port output as the reset signal. Apart from these pins, the power and ground pin
connections are usually also required.
Note: When the IC card is not connected and both RE and TE are set to 1, closed communication
18.3.3
Figure 18.3 shows the data format for the smart card interface. In this mode, parity is checked
every frame while receiving and error signals sent to the transmitting side whenever an error is
detected so that data can be re-transmitted. During transmission, error signals are sampled and data
re-transmitted whenever an error signal is detected.
CC
side with a resistor.
is possible and auto-diagnosis can be performed.
Pin Connections
Data Format
Figure 18.2 Pin Connection Diagram for the Smart Card Interface
Connected device
LSI
TxD0
RxD0
SCK0
Px (port)
Reset line
Clock line
Data line
Rev.6.00 Mar. 27, 2009 Page 549 of 1036
V
CC
Section 18 Smart Card Interface
IO
CLK
RST
IC card
REJ09B0254-0600