NH82801FBM S L89K Intel, NH82801FBM S L89K Datasheet - Page 619

• Manufacturer Part Number: NH82801FBM S L89K
• Manufacturer: Intel

Specifications of NH82801FBM S L89K

• Lead Free Status / RoHS Status: Compliant

17.2.4
Intel
®
I/O Controller Hub 6 (ICH6) Family Datasheet
x_SR—Status Register (Modem—D30:F3)
I/O Address:
Default Value:
Lockable:
Software can read the registers at offsets 04h, 05h and 06h simultaneously by performing a single,
32-bit read from address offset 04h. Software can also read this register individually by doing a
single, 16-bit read to offset 06h. Reads across DWord boundaries are not supported.
15:5
Bit
4
3
2
1
0
Reserved
FIFO Error (FIFOE) — R/WC.
0 = Software clears this bit by writing a 1 to it.
1 = FIFO error occurs.
Modem in: FIFO error indicates a FIFO overrun. The FIFO pointers don't increment, the incoming
data is not written into the FIFO, thereby being lost.
Modem out: FIFO error indicates a FIFO underrun. The sample transmitted in this case should be
the last valid sample.
The ICH6 will set the FIFOE bit if the under-run or overrun occurs when there are more valid buffers
to process.
Buffer Completion Interrupt Status (BCIS) — R/WC.
0 = Software clears this bit by writing a 1 to it.
1 = Set by the hardware after the last sample of a buffer has been processed, AND if the Interrupt
Last Valid Buffer Completion Interrupt (LVBCI) — R/WC.
0 = Software clears this bit by writing a 1 to it.
1 = Set by hardware when last valid buffer has been processed. It remains active until cleared by
Current Equals Last Valid (CELV) — RO.
0 = Hardware clears when controller exists state (i.e., until a new value is written to the LVI
1 = Current Index is equal to the value in the Last Valid Index Register, AND the buffer pointed to
DMA Controller Halted (DCH) — RO.
0 = Running.
1 = Halted. This could happen because of the Start/Stop bit being cleared and the DMA engines
on Completion (IOC) bit is set in the command byte of the buffer descriptor. Remains active
until software clears bit.
software. This bit indicates the occurrence of the event signified by the last valid buffer being
processed. Thus, this is an event status bit that can be cleared by software once this event has
been recognized. This event will cause an interrupt if the enable bit in the Control Register is
set. The interrupt is cleared when the software clears this bit.
In the case of transmits (PCM out, Modem out) this bit is set, after the last valid buffer has been
fetched (not after transmitting it). While in the case of Receives, this bit is set after the data for
the last buffer has been written to memory.
register).
by the CIV has been processed (i.e., after the last valid buffer has been processed). This bit is
very similar to bit 2, except, this bit reflects the state rather than the event. This bit reflects the
state of the controller, and remains set until the controller exits this state.
are idle, or it could happen once the controller has processed the last valid buffer.
MBAR + 06h (MISR),
MBAR + 16h (MOSR)
0001h
No
AC ’97 Modem Controller Registers (D30:F3)
Description
Attribute:
Size:
Power Well:
R/WC, RO
16 bits
Core
619