NH82801FBM S L89K Intel, NH82801FBM S L89K Datasheet - Page 139

• Manufacturer Part Number: NH82801FBM S L89K
• Manufacturer: Intel

Specifications of NH82801FBM S L89K

• Lead Free Status / RoHS Status: Compliant

5.10.3
5.10.4
Intel
Table 5-15. APIC Interrupt Mapping (Sheet 2 of 2)
®
I/O Controller Hub 6 (ICH6) Family Datasheet
Note: FSB Interrupt Delivery compatibility with processor clock control depends on the processor, not
NOTES:
PCI / PCI Express* Message-Based Interrupts
When external devices through PCI / PCI Express wish to generate an interrupt, they will send the
message defined in the PCI Express* Base Specification, Revision 1.0a for generating INTA# -
INTD#. These will be translated internal assertions/de-assertions of INTA# - INTD#.
Front Side Bus Interrupt Delivery
For processors that support Front Side Bus (FSB) interrupt delivery, the ICH6 requires that the I/O
APIC deliver interrupt messages to the processor in a parallel manner, rather than using the I/O
APIC serial scheme.
This is done by the ICH6 writing (via DMI) to a memory location that is snooped by the
processor(s). The processor(s) snoop the cycle to know which interrupt goes active.
The following sequence is used:
the ICH6.
1. IDEIRQ can only be driven directly from the pin when in legacy IDE mode.
2. When programming the polarity of internal interrupt sources on the APIC, interrupts 0 through 15 receive
3. If IRQ 11 is used for HPET #2, software should ensure IRQ 11 is not shared with any other devices to
1. When the ICH6 detects an interrupt event (active edge for edge-triggered mode or a change for
2. Internally, the ICH6 requests to use the bus in a way that automatically flushes upstream
3. The ICH6 then delivers the message by performing a write cycle to the appropriate address
IRQ #
active-high internal interrupt sources, while interrupts 16 through 23 receive active-low internal interrupt
sources.
guarantee the proper operation of HPET #2. ICH6 hardware does not prevent sharing of IRQ 11.
16
17
18
19
20
21
22
23
level-triggered mode), it sets or resets the internal IRR bit associated with that interrupt.
buffers. This can be internally implemented similar to a DMA device request.
with the appropriate data. The address and data formats are described below in
Section
SERIRQ
PIRQA#
PIRQB#
PIRQC#
PIRQD#
5.10.4.4.
N/A
N/A
N/A
N/A
Via
Direct from
PIRQC#
PIRQD#
PIRQG#
PIRQH#
PIRQA#
PIRQB#
PIRQE#
PIRQF#
Pin
Message
Via PCI
Yes
Yes
Internal devices are routable; see
Section
Option for SCI, TCO, HPET #0,1,2. Other internal
devices are routable; see
Section
7.1.50.
7.1.50.
Internal Modules
Section 7.1.41
Functional Description
Section 7.1.41
thru
thru
139