mpc823rg Freescale Semiconductor, Inc, mpc823rg Datasheet - Page 843

• Manufacturer Part Number: mpc823rg
• Description: Mpc823 Powerquicc Integrated Communications Processor For Portable Systems
• Manufacturer: Freescale Semiconductor, Inc

When the buffer descriptor data is completely written to the transmit FIFO, the SMCx UART
controller writes the message status bits into the buffer descriptor and clears the R bit. An
interrupt is issued if the I bit in the buffer descriptor is set. If the next TX buffer descriptor is
ready, the data from its data buffer is appended to the previous data and transmitted out on
the transmit pin, without any gaps between the buffers. If the next TX buffer descriptor is not
ready, the SMCx UART controller starts transmitting idles and waits for the next TX buffer
descriptor to be ready.
By appropriately setting the I bit in each buffer descriptor, interrupts can be generated after
the transmission of each buffer, a specific buffer, or each block. The SMCx UART controller
then proceeds to the next buffer descriptor in the table. If the CM bit is set in the TX buffer
descriptor, the R bit is not cleared, allowing the associated data buffer to be automatically
retransmitted next time the communication processor module accesses this data buffer. For
instance, if a single TX buffer descriptor is initialized with the CM and W bits set, the data
buffer is continuously transmitted until you clear the R bit of the buffer descriptor.
16.11.6.3 SMCx UART CHANNEL RECEPTION PROCESS. When the core enables the
SMCx receiver in UART mode, it enters hunt mode and waits for the first character to arrive.
Once the first character arrives, the communication processor module checks the first
receive buffer descriptor to see if it is empty and then starts storing characters in the
associated data buffer.
When the data buffer is filled or the MAX_IDL timer expires (if it is enabled) the SMCx UART
controller clears the E bit in the buffer descriptor and generates an interrupt if the I bit in the
buffer descriptor is set. If the incoming data exceeds the length of the data buffer, the SMCx
UART controller fetches the next buffer descriptor in the table and, if it is empty, continues
transferring data to the associated data buffer. If the CM bit is set in the receive buffer
descriptor, the E bit is not cleared, which allows the associated data buffer to be
automatically overwritten next time the communication processor module accesses this
data buffer.
16.11.6.4 SMCx UART PARAMETER RAM MEMORY MAP. When a serial management
controller is configured to operate in UART mode, the SMCx UART controller overlays the
structure used in Table 16-36 with the parameters described in Table 16-37.
NOTE:
SMCx Base + 2C
SMCx Base + 28
SMCx Base + 2A
SMCx Base + 2E
SMCx Base +30
SMCx Base +32
ADDRESS
You are only responsible for initializing the items in bold.
SMCx Base = (IMMR & 0xFFFF0000) + 0x3E80 (SMC1) and 0x3F80 (SMC2).
Table 16-37. SMCx UART Parameter RAM Memory Map
Freescale Semiconductor, Inc.
MAX_IDL
R_MASK
BRKEC
BRKCR
For More Information On This Product,
BRKLN
NAME
IDLC
MPC823 REFERENCE MANUAL
Go to: www.freescale.com
Half-word
Half-word
Half-word
Half-word
Half-word
Half-word
WIDTH
Receive Break Condition Counter
Break Count Register (Transmit)
Last Received Break Length
Communication Processor Module
Maximum Idle Characters
Temporary Idle Counter
Temporary Bit Mask
DESCRIPTION
16-391