R4F24278NVFQU Renesas Electronics America, R4F24278NVFQU Datasheet - Page 348

• Manufacturer Part Number: R4F24278NVFQU
• Description: MCU 512K/48K 2.7-5.5V 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24278NVFQU

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, Smart Card, SPI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 98
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Section 7 Bus Controller (BSC)
7.13.2
Even if a bus request is received from a bus master with a higher priority than that of the bus
master that has acquired the bus and is currently operating, the bus is not necessarily transferred
immediately. There are specific timings at which each bus master can relinquish the bus.
(1)
The CPU is the lowest-priority bus master, and if a bus request is received from the DTC, DMAC,
or EXDMAC*, the bus arbiter transfers the bus to the bus master that issued the request. The
timing for transfer of the bus is as follows:
• The bus is transferred at a break between bus cycles. However, if a bus cycle is executed in
• With bit manipulation instructions such as BSET and BCLR, the sequence of operations is:
• If the CPU is in sleep mode, the bus is transferred immediately.
Note: * The EXDMAC is not supported by the H8S/2425 Group.
(2)
The DTC sends the bus arbiter a request for the bus when an activation request is generated.
The DTC can release the bus after a vector read, a register information read (3 states), a single data
transfer, or a register information write (3 states). It does not release the bus during a register
information read (3 states), a single data transfer, or a register information write (3 states).
(3)
The DMAC sends the bus arbiter a request for the bus when an activation request is generated.
In the case of an external request in short address mode or normal mode, and in cycle steal mode,
the DMAC releases the bus after a single transfer.
In block transfer mode, it releases the bus after transfer of one block, and in burst mode, after
completion of the transfer. However, in the event of an EXDMAC* or external bus release
request, which have a higher priority than the DMAC, the bus may be transferred to the bus master
even if block or burst transfer is in progress.
Note: * Not supported by the H8S/2425 Group.
Page 318 of 1448
discrete operations, as in the case of a longword-size access, the bus is not transferred between
the component operations.
data read (read), relevant bit manipulation operation (modify), write-back (write). The bus is
not transferred during this read-modify-write cycle, which is executed as a series of bus cycles.
CPU
DTC
DMAC
Bus Transfer Timing
H8S/2427, H8S/2427R, H8S/2425 Group
REJ09B0565-0100 Rev. 1.00
Jul 22, 2010