R4F24278NVFQU Renesas Electronics America, R4F24278NVFQU Datasheet - Page 1047

• Manufacturer Part Number: R4F24278NVFQU
• Description: MCU 512K/48K 2.7-5.5V 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24278NVFQU

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, Smart Card, SPI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 98
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

H8S/2427, H8S/2427R, H8S/2425 Group
17.4.4
In slave transmit mode, the slave device outputs the transmit data, while the master device outputs
the receive clock and returns an acknowledge signal.
The transmission procedure and operations in slave transmit mode are described below.
1. Set the ICE bit in ICCRA to 1. Set the MLS and WAIT bits in ICMR and the CKS3 to CKS0
2. When the slave address matches in the first frame following detection of the start condition,
3. If TDRE is set after writing last transmit data to ICDRT, wait until TEND in ICSR is set to 1,
4. Clear TRS for the end processing, and read ICDRR (dummy read). SCL is free.
5. Clear TDRE.
REJ09B0565-0100 Rev. 1.00
Jul 22, 2010
bits in ICCRA to 1. (Initial setting) Set the MST and TRS bits in ICCRA to select slave receive
mode, and wait until the slave address matches.
the slave device outputs the level specified by ACKBT in ICIER to SDA, at the rise of the 9th
clock pulse. At this time, if the 8th bit data (R/W) is 1, the TRS in ICCRA and TDRE in ICSR
are set to 1, and the mode changes to slave transmit mode automatically. The continuous
transmission is performed by clearing TDRE after writing transmit data to ICDRT every time
TDRE is set.
with TDRE = 1. When TEND is set, clear TEND.
Slave Transmit Operation
Section 17 I
2
C Bus Interface 2 (IIC2)
Page 1017 of 1448