R4F24278NVFQU Renesas Electronics America, R4F24278NVFQU Datasheet - Page 1003

• Manufacturer Part Number: R4F24278NVFQU
• Description: MCU 512K/48K 2.7-5.5V 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24278NVFQU

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, Smart Card, SPI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 98
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

H8S/2427, H8S/2427R, H8S/2425 Group
When Changing from Smart Card Interface Mode to Software Standby Mode:
1. Set the data register (DR) and data direction register (DDR) corresponding to the SCK pin to
2. Write 0 to the TE bit and RE bit in the serial control register (SCR) to halt transmit/receive
3. Write 0 to the CKE0 bit in SCR to halt the clock.
4. Wait for one serial clock cycle.
5. Make the transition to the software standby state.
When Returning to Smart Card Interface Mode from Software Standby Mode:
6. Exit the software standby state.
7. Write 1 to the CKE0 bit in SCR and output the clock. Signal generation is started with the
REJ09B0565-0100 Rev. 1.00
Jul 22, 2010
the value for the fixed output state in software standby mode.
operation. At the same time, set the CKE1 bit to the value for the fixed output state in software
standby mode.
During this interval, clock output is fixed at the specified level, with the duty cycle preserved.
normal duty cycle.
[1] [2] [3]
Normal operation
Figure 16.32 Clock Halt and Restart Procedure
[4] [5]
Software
standby
Section 16 Serial Communication Interface (SCI, IrDA, CRC)
[6]
[7]
Normal operation
Page 973 of 1448