DF2134AFA20V Renesas Electronics America, DF2134AFA20V Datasheet - Page 175

• Manufacturer Part Number: DF2134AFA20V
• Description: IC H8S/2100 MCU FLASH 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2134AFA20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 58
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• For Use With: 3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

5.4.3
ABRKCR and BAR settings can be made so that an address break interrupt is generated when the
CPU prefetches the address set in BAR. This address break function issues an interrupt request to
the interrupt controller when the address is prefetched, and the interrupt controller determines the
interrupt priority. When the interrupt is accepted, interrupt exception handling is started on
completion of the currently executing instruction. With an address break interrupt, interrupt mask
control by the I and UI bits in the CPU’s CCR is ineffective.
The register settings when the address break function is used are as follows.
1. Set the break address in bits A23 to A1 in BAR.
2. Set the BIE bit in ABRKCR to 1 to enable address breaks. An address break will not be
When the setting condition occurs, the CMF flag in ABRKCR is set to 1 and an interrupt is
requested. If necessary, the source should be identified in the interrupt handling routine.
5.4.4
1. With the address break function, the address at which the first instruction byte is located
2. In normal mode, no comparison is made with address lines A23 to A16.
3. If a branch instruction (Bcc, BSR), jump instruction (JMP, JSR), RTS instruction, or RTE
4. As an address break interrupt is generated by a combination of the internal prefetch signal and
requested if the BIE bit is cleared to 0.
should be specified as the break address. Occurrence of the address break condition may not be
recognized for other addresses.
instruction is located immediately before the address set in BAR, execution of this instruction
will output a prefetch signal for that address, and an address break may be requested. This can
be prevented by not making a break address setting for an address immediately following one
of these instructions, or by determining within the interrupt handling routine whether interrupt
handling was initiated by a genuine condition occurrence.
address, the timing of the start of interrupt exception handling depends on the content and
execution cycle of the instruction at the set address and the preceding instruction. Figure 5.6
shows some address timing examples.
Operation
Usage Notes
Rev. 4.00 Jun 06, 2006 page 119 of 1004
Section 5 Interrupt Controller
REJ09B0301-0400