ATSAM3S1BA-AU Atmel, ATSAM3S1BA-AU Datasheet - Page 875

• Manufacturer Part Number: ATSAM3S1BA-AU
• Description: IC MCU 32BIT 64KB FLASH 64LQFP
• Manufacturer: Atmel
• Series: SAM3Sr

Specifications of ATSAM3S1BA-AU

• Core Processor: ARM® Cortex-M3™
• Core Size: 32-Bit
• Speed: 64MHz
• Connectivity: I²C, MMC, SPI, SSC, UART/USART, USB
• Peripherals: Brown-out Detect/Reset, DMA, I²S, POR, PWM, WDT
• Number Of I /o: 47
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.62 V ~ 1.95 V
• Data Converters: A/D 10x10/12b, D/A 2x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Controller Family/series: ATSAM3S
• No. Of I/o's: 47
• Ram Memory Size: 16KB
• Cpu Speed: 64MHz
• No. Of Timers: 6
• Rohs Compliant: Yes
• Processor Series: ATSAM3x
• Core: ARM Cortex M3
• 3rd Party Development Tools: JTRACE-CM3, MDK-ARM, RL-ARM, ULINK2
• Development Tools By Supplier: ATSAM3S-EK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

36.6.5.6
6500C–ATARM–8-Feb-11
Interrupts
Depending on the interrupt mask in the PWM_IMR1 and PWM_IMR2 registers, an interrupt can
be generated at the end of the corresponding channel period (CHIDx in the PWM_ISR1 regis-
ter), after a fault event (FCHIDx in the PWM_ISR1 register), after a comparison match (CMPMx
in the PWM_ISR2 register), after a comparison update (CMPUx in the PWM_ISR2 register) or
according to the transfer mode of the synchronous channels (WRDY, ENDTX, TXBUFE and
UNRE in the PWM_ISR2 register).
If the interrupt is generated by the flags CHIDx or FCHIDx, the interrupt remains active until a
read operation in the PWM_ISR1 register occurs.
If the interrupt is generated by the flags WRDY or UNRE or CMPMx or CMPUx, the interrupt
remains active until a read operation in the PWM_ISR2 register occurs.
A channel interrupt is enabled by setting the corresponding bit in the PWM_IER1 and
PWM_IER2 registers. A channel interrupt is disabled by setting the corresponding bit in the
PWM_IDR1 and PWM_IDR2 registers.
SAM3S Preliminary
875