EP4SE530H40I3 Altera, EP4SE530H40I3 Datasheet - Page 21

• Manufacturer Part Number: EP4SE530H40I3
• Description: IC STRATIX IV FPGA 530K 1517HBGA
• Manufacturer: Altera
• Series: STRATIX® IV Er

Specifications of EP4SE530H40I3

• Number Of Logic Elements/cells: 531200
• Number Of Labs/clbs: 21248
• Total Ram Bits: 27376
• Number Of I /o: 976
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 1517-HBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -

Chapter 1: Overview for the Stratix IV Device Family
Architecture Features
February 2011 Altera Corporation
f
■
■
■
Diagnostic Features
■
■
■
For more information, refer to the
Signal Integrity
Stratix IV devices simplify the challenge of signal integrity through a number of chip,
package, and board-level enhancements to enable efficient high-speed data transfer
into and out of the device. These enhancements include:
■
■
■
■
■
■
XAUI/HiGig Support
■
■
■
GbE Support
■
■
■
Support for other protocol features such as MSB-to-LSB transmission in
SONET/SDH configuration and spread-spectrum clocking in PCIe configurations
Serial loopback from the transmitter serializer to the receiver CDR for transceiver
PCS and PMA diagnostics
Reverse serial loopback pre- and post-CDR to transmitter buffer for physical link
diagnostics
Loopback master and slave capability in PCI Express hard IP blocks
Programmable 3-tap transmitter pre-emphasis with up to 8,192 pre-emphasis
levels to compensate for pre-cursor and post-cursor inter-symbol interference (ISI)
Up to 900% boost capability on the first pre-emphasis post-tap
User-controlled and adaptive 4-stage receiver equalization with up to 16 dB of
high-frequency gain
On-die power supply regulators for transmitter and receiver phase-locked loop
(PLL) charge pump and voltage controlled oscillator (VCO) for superior noise
immunity
On-package and on-chip power supply decoupling to satisfy transient current
requirements at higher frequencies, thereby reducing the need for on-board
decoupling capacitors
Calibration circuitry for transmitter and receiver on-chip termination (OCT)
resistors
Compliant to IEEE802.3ae specification
Embedded state machine circuitry to convert XGMII idle code groups (||I||)
to and from idle ordered sets (||A||, ||K||, ||R||) at the transmitter and
receiver, respectively
8B/10B encoder and decoder, receiver synchronization state machine, lane
deskew, and ± 100 ppm clock compensation circuitry
Compliant to IEEE802.3-2005 specification
Automatic idle ordered set (/I1/, /I2/) generation at the transmitter,
depending on the current running disparity
8B/10B encoder and decoder, receiver synchronization state machine, and
± 100 ppm clock compensation circuitry
PCI Express Compiler User
Stratix IV Device Handbook Volume 1
Guide.
1–7