HD64F7047F50V Renesas Electronics America, HD64F7047F50V Datasheet - Page 658

• Manufacturer Part Number: HD64F7047F50V
• Description: IC H8 MCU FLASH 256K 100TQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7047r

Specifications of HD64F7047F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Package: 100PQFP
• Family Name: SuperH
• Maximum Speed: 50 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 53
• Interface Type: CAN/SCI
• On-chip Adc: 16-chx10-bit
• Number Of Timers: 7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

24.4.2
Current consumption increases during the oscillation stabilization wait period.
24.4.3
Relevant interrupt operations cannot be performed in module standby mode. Consequently, if the
CPU enters module standby mode while an interrupt has been requested, it will not be possible to
clear the CPU interrupt source or the DTC activation source.
Interrupts should therefore be disabled before entering module standby mode.
24.4.4
MSTCR1 and MSTCR2 should only be written to by the CPU.
24.4.5
Power should not be supplied while the HSTBY pin is at the low level. To enter hardware standby
mode, the HSTBY pin can be set to the low level when the oscillation stabilization time has
elapsed after power supply.
24.4.6
The HSTBY signal controls start and stop for all functions of this LSI, including the clock pulse
generator. Therefore, please keep in mind that electromagnetic interference on the HSTBY pin
causes malfunction of this LSI.
If using the hardware standby function of this LSI which is exposed to the environment in which
lots of electromagnetic interference sources exist, connecting a noise filter such as an R-C circuit
shown in figure 24.4 to the HSTBY pin is recommended.
Rev. 2.00, 09/04, page 616 of 720
Current Consumption during Oscillation Stabilization Wait Period
On-Chip Peripheral Module Interrupt
Writing to MSTCR1 and MSTCR2
Handling of HSTBY Pin
Electromagnetic Interference on HSTBY Pin
Figure 24.4 Example of External Circuit Connected to HSTBY Pin
control curcuit
HSTBY
R
C: 0.1µF
R: 10k to 100k Ω (recommendation)
C
This LSI
HSTBY