HD64F7047F50V Renesas Electronics America, HD64F7047F50V Datasheet - Page 534

• Manufacturer Part Number: HD64F7047F50V
• Description: IC H8 MCU FLASH 256K 100TQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7047r

Specifications of HD64F7047F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Package: 100PQFP
• Family Name: SuperH
• Maximum Speed: 50 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 53
• Interface Type: CAN/SCI
• On-chip Adc: 16-chx10-bit
• Number Of Timers: 7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

16.4.1
An example of the operating mode setting procedure is shown in figure 16.2.
Rev. 2.00, 09/04, page 492 of 720
Sample Setting Procedure
Set dead time carrier period
Set external pin functions
Set PWM output level
Start count operation
Halt count operation
Set operating mode
<Operating mode>
Set TCNT
Set TBR
Figure 16.2 Sample Operating Mode Setting Procedure
Set the external pin functions with the pin function
controller (PFC).
Clear the CST bit to 0 in the timer control register
(TCNR) to halt timer counter operation. Make the
operating mode setting while TCNT is halted.
Set 2Td (Td: dead time) in TCNT.
Set dead time Td in the dead time data register
(TDDR), set 1/2 the carrier period in the timer period
buffer register (TPBR), and set {TPBR value + 2Td}
in the timer period data register (TPDR).
Set the output PWM duty cycle {PWM duty cycle
initial value – Td} in the free operation addresses of
the buffer registers (TBRU, TBRV, TBRW).
Set the operating mode in the timer mode register
(TMDR). The PUOA, PUOB, PVOA, PVOB, PWOA,
and PWOB pins are output pins.
Set the CST bit to 1 in TCNR to start the count
operation.
Set the PWM output level with bits OLSN and OLSP
in the timer mode register (TMDR).