R4F24568NVFQV Renesas Electronics America, R4F24568NVFQV Datasheet - Page 470

• Manufacturer Part Number: R4F24568NVFQV
• Description: MCU 128KKB FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24568NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 32MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 8 EXDMA Controller (EXDMAC)
When transfer is halted by writing 0 to the EDA bit, the EDA bit remains at 1 during the EXDMA
transfer period. In block transfer mode, since a block-size transfer is carried out without
interruption, the EDA bit remains at 1 from the time 0 is written to it until the end of the current
block-size transfer.
In burst mode, transfer is halted for up to three EXDMA transfers following the bus cycle in
which 0 is written to the EDA bit. The EDA bit remains set to 1 from the time of the 0-write until
the end of the last DMA cycle.
Writes (except to the EDA bit) are prohibited to registers of a channel for which the EDA bit is set
to 1. When changing register settings after a 0-write to the EDA bit, it is necessary to confirm that
the EDA bit has been cleared to 0.
Figure 8.12 shows the procedure for changing register settings in an operating channel.
Page 440 of 1392
Changing register settings
Change register settings
Figure 8.12 Procedure for Changing Register Settings in Operating Channel
changes completed
in operating channel
Write 0 to EDA bit
Register setting
Read EDA bit
EDA bit = 0?
Yes
No
[1]
[2]
[3]
[4]
[1] Write 0 to the EDA bit in EDMDR.
[2] Read the EDA bit.
[3] Confirm that EDA = 0. If EDA = 1, this
[4] Write the required set values to the registers.
indicates that EXDMA transfer is in progress.
H8S/2456, H8S/2456R, H8S/2454 Group
REJ09B0467-0350 Rev. 3.50
Jul 07, 2010