R4F24568NVFQV Renesas Electronics America, R4F24568NVFQV Datasheet - Page 1216

• Manufacturer Part Number: R4F24568NVFQV
• Description: MCU 128KKB FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24568NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 32MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Flash Memory
(7)
A command error will occur when a command is undefined, the order of commands is incorrect,
or a command is unacceptable. Issuing a clock-mode selection command before a device selection
or an inquiry command after the transition to programming/erasing state command, are examples.
• Error response, H'80, (1 byte): Command error
• Command, H'xx, (1 byte): Received command
(8)
The order for commands in the inquiry/selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
5. After selection of the device and clock mode, inquiries for other required information should
6. A new bit rate should be selected with the new bit-rate selection (H'3F) command, according
7. After selection of the device and clock mode, inquiries for the information of
8. After making inquiries and selecting a new bit rate, issue the transition to
Page 1186 of 1392
Error Response
with a device-selection (H'10) command.
and set.
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
to the returned information on multiplication ratios and operating frequencies.
programming/erasing to the user ROM should be made by the user ROMs information inquiry
(H'25), erased block information inquiry (H'26), and programming unit inquiry (H'27).
programming/erasing state command (H'40). The boot program will then enter the
programming/erasing state.
Command Error
Command Order
H'80
H'xx
H8S/2456, H8S/2456R, H8S/2454 Group
REJ09B0467-0350 Rev. 3.50
Jul 07, 2010