R4F24568NVFQV Renesas Electronics America, R4F24568NVFQV Datasheet - Page 341

• Manufacturer Part Number: R4F24568NVFQV
• Description: MCU 128KKB FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24568NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 32MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

H8S/2456, H8S/2456R, H8S/2454 Group
6.12
This LSI can release the external bus in response to a bus request from an external device. In the
external bus released state, internal bus masters except the EXDMAC * continue to operate as long
as there is no external access. If any of the following requests are issued in the external bus
released state, the BREQO signal can be driven low to output a bus request externally.
• When an internal bus master wants to perform an external access
• When a refresh request is generated
• When a SLEEP instruction is executed to place the chip in software standby mode or all-
Note: * Not supported by the H8S/2454 Group.
6.12.1
In externally expanded mode, the bus can be released to an external device by setting the BRLE
bit to 1 in BCR. Driving the BREQ pin low issues an external bus request to this LSI. When the
BREQ pin is sampled, at the prescribed timing the BACK pin is driven low, and the address bus,
data bus, and bus control signals are placed in the high-impedance state, establishing the external
bus released state.
In the external bus released state, internal bus masters except the EXDMAC* can perform
accesses using the internal bus. When an internal bus master wants to make an external access, it
temporarily defers initiation of the bus cycle, and waits for the bus request from the external bus
master to be canceled. If a refresh request is generated in the external bus released state, or if a
SLEEP instruction is executed to place the chip in software standby mode or all-module-clocks-
stopped mode, refresh control and software standby or all-module-clocks-stopped control is
deferred until the bus request from the external bus master is canceled.
If the BREQOE bit is set to 1 in BCR, the BREQO pin can be driven low when any of the
following requests are issued, to request cancellation of the bus request externally.
• When an internal bus master wants to perform an external access
• When a refresh request is generated
• When a SLEEP instruction is executed to place the chip in software standby mode or all-
When the BREQ pin is driven high, the BACK pin is driven high at the prescribed timing and the
external bus released state is terminated.
REJ09B0467-0350 Rev. 3.50
Jul 07, 2010
module-clocks-stopped mode
module-clocks-stopped mode
Bus Release
Operation
Section 6 Bus Controller (BSC)
Page 311 of 1392