HD6413007F20 Renesas Electronics America, HD6413007F20 Datasheet - Page 81

• Manufacturer Part Number: HD6413007F20
• Description: IC H8 MCU ROMLESS 5V 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD6413007F20

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 35
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

2.8.2
In this state the CPU executes program instructions in normal sequence.
2.8.3
The exception-handling state is a transient state that occurs when the CPU alters the normal
program flow due to a reset, interrupt, or trap instruction. The CPU fetches a starting address from
the exception vector table and branches to that address. In interrupt and trap exception handling
the CPU references the stack pointer (ER7) and saves the program counter and condition code
register.
Types of Exception Handling and Their Priority: Exception handling is performed for resets,
interrupts, and trap instructions. Table 2.14 indicates the types of exception handling and their
priority. Trap instruction exceptions are accepted at all times in the program execution state.
Table 2.14 Exception Handling Types and Priority
Figure 2.12 classifies the exception sources. For further details about exception sources, vector
numbers, and vector addresses, see section 4, Exception Handling, and section 5, Interrupt
Controller.
Note: * Interrupts are not detected at the end of the ANDC, ORC, XORC, and LDC instructions,
Priority
High
Low
or immediately after reset exception handling.
Program Execution State
Exception-Handling State
Type of Exception Detection Timing
Reset
Interrupt
Trap instruction
Synchronized with clock
End of instruction
execution or end of
exception handling*
When TRAPA instruction
is executed
Rev.5.00 Sep. 12, 2007 Page 51 of 764
Start of Exception Handling
Exception handling starts immediately
when RES changes from low to high
When an interrupt is requested,
exception handling starts at the end of
the current instruction or current
exception-handling sequence
Exception handling starts when a trap
(TRAPA) instruction is executed
REJ09B0396-0500
2. CPU