HD6413007F20 Renesas Electronics America, HD6413007F20 Datasheet - Page 593

• Manufacturer Part Number: HD6413007F20
• Description: IC H8 MCU ROMLESS 5V 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD6413007F20

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 35
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

19.4
19.4.1
To enter software standby mode, execute the SLEEP instruction while the SSBY bit is set to 1 in
SYSCR.
In software standby mode, current dissipation is reduced to an extremely low level because the
CPU, clock, and on-chip supporting modules all halt. The DMAC and on-chip supporting modules
are reset and halted. As long as the specified voltage is supplied, however, CPU register contents
and on-chip RAM data are retained. The settings of the I/O ports and DRAM interface* are also
held.
When the WDT is used as a watchdog timer (WT/IT = 1), the TME bit must be cleared to 0 before
setting SSBY. Also, when setting TME to 1, SSBY should be cleared to 0.
Clear the BRLE bit in BRCR (inhibiting bus release) before making a transition to software
standby mode.
Note: * RTCNT and bits 7 and 6 of RTMCSR are initialized. Other bits and registers hold their
19.4.2
Software standby mode can be exited by input of an external interrupt at the NMI, IRQ
IRQ
Exit by Interrupt: When an NMI, IRQ
clock oscillator begins operating. After the oscillator settling time selected by bits STS2 to STS0
in SYSCR, stable clock signals are supplied to the entire chip, software standby mode ends, and
interrupt exception handling begins. Software standby mode is not exited if the interrupt enable
bits of interrupts IRQ
CPU.
Exit by RES Input: When the RES input goes low, the clock oscillator starts and clock pulses are
supplied immediately to the entire chip. The RES signal must be held low long enough for the
clock oscillator to stabilize. When RES goes high, the CPU starts reset exception handling.
Exit by STBY Input: Low input at the STBY pin causes a transition to hardware standby mode.
2
pin, or by input at the RES or STBY pin.
Software Standby Mode
Transition to Software Standby Mode
Exit from Software Standby Mode
previous states.
0
, IRQ
1
, and IRQ
2
are cleared to 0, or if these interrupts are masked in the
0
, IRQ
1
, or IRQ
2
interrupt request signal is received, the
Rev.5.00 Sep. 12, 2007 Page 563 of 764
19. Power-Down State
REJ09B0396-0500
0
, IRQ
1
, or