HD6413007F20 Renesas Electronics America, HD6413007F20 Datasheet - Page 263

• Manufacturer Part Number: HD6413007F20
• Description: IC H8 MCU ROMLESS 5V 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD6413007F20

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 35
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

7.4.9
The DMAC channel priority order is: channel 0 > channel 1 and channel A > channel B.
Table 7.12 shows the complete priority order.
Table 7.12 Channel Priority Order
Short Address Mode
Channel 0A
Channel 0B
Channel 1A
Channel 1B
If transfers are requested on two or more channels simultaneously, or if a transfer on one channel
is requested during a transfer on another channel, the DMAC operates as follows.
• When a transfer is requested, the DMAC requests the bus right. When it gets the bus right, it
• Once a transfer starts on one channel, requests to other channels are held pending until that
• After each transfer in short address mode, and each externally-requested or cycle-steal transfer
• After completion of a burst-mode transfer, or after transfer of one block in block transfer
Figure 7.19 shows the timing when channel 0A is set up for I/O mode and channel 1 for burst
mode, and a transfer request for channel 0A is received while channel 1 is active.
starts a transfer on the highest-priority channel at that time.
channel releases the bus.
in normal mode, the DMAC releases the bus and returns to step 1. After releasing the bus, if
there is a transfer request for another channel, the DMAC requests the bus again.
mode, the DMAC releases the bus and returns to step 1. If there is a transfer request for a
higher-priority channel or a bus request from a higher-priority bus master, however, the
DMAC releases the bus after completing the transfer of the current byte or word. After
releasing the bus, if there is a transfer request for another channel, the DMAC requests the bus
again.
Multiple-Channel Operation
Full Address Mode
Channel 0
Channel 1
Rev.5.00 Sep. 12, 2007 Page 233 of 764
Priority
High
Low
7. DMA Controller
REJ09B0396-0500