XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 52

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

Basic Operating Procedure
3. The Change PLC Dialog Box will be displayed as shown below. Click the
4. The following dialog box will be displayed. Click the Yes Button to convert
5. The following dialog box will be displayed. If the Yes Button is clicked, the
6. The conversion will be processed when the Yes Button in the following di-
Settings Button to the right of the Device Type Field. The Device Type Set-
tings Dialog Box will be displayed. Change the CPU type to “002” and click
the OK Button.
the program.
Serial PLC Link Areas will be converted even if serial PLC links are not be-
ing used. If any part of the Serial PLC Link Areas is used as work bits in
the program, check the program to be sure that no problems have resulted
from conversion (e.g., only part of continuous data may be converted) and
manually correct the program as required.
alog box is clicked. If the following words in the DM Area are continuously
written from a PT or using the DM transfer function (excluding writing from
the program), the service life of the built-in flash ROM will be exhausted
sooner. Use other words to prevent this.
Also, these DM Area words are not cleared at startup for the FQM1-
CM002. If they must be cleared at startup, include suitable instructions to
clear them from the ladder program.
This dialog box appears only when converting between the FQM1-CM001
and FQM1-CM002.
Section 1-6
25