XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 205

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

Serial Communications
System Setup
6-1-3
System Setup
PT System Menu
Data Exchange between
Motion Control Modules
and PTs
178
NT Link (1:N Mode)
1,2,3...
Note
Note
Refer to the Instructions Reference Manual (Cat. No. O011) for more details
on the TXD(236) and RXD(235) instructions.
RS-232C Settings (Host Link Port Settings)
The settings are made using CX-Programmer (Ver. 6.11 or higher) menus.
With the FQM1, communications are possible with PTs (Programmable Termi-
nals) using NT Links (1:N mode).
Communications are not possible using the 1:1-mode NT Link protocol. Also,
the standard baud rate must be used.
The settings can be made using System Setup and the PT system menu.
Set the PT as follows:
1. Select NT Link (1:N) from the Comm. A Method or Comm. B Method on
2. Press the SET Touch Switch to set the Comm. Speed to Standard. High-
The following settings are not required if the PT is exchanging data with the
Coordinator Module only. If the PT will be exchanging data with Motion Con-
trol Modules, routing table settings must be made for the PT.
TXD(236) instruction
Mode
Delay
End Code
Start Code
Received bytes
Use of end code
Use of start code
Peripheral
port
RS-232C
port
Communi-
cations
port
the Memory Switch Menu in the System Menu on the PT.
speed communications are not possible.
Transmission
delay time
Item
Mode
Baud
NT Link max.
Mode
Baud
NT Link max.
Name
Transmission
RS-232C
0 to 99,990 ms (unit: 10 ms)
00 to FF hex
00 to FF hex
1 to 255 bytes
Received bytes or CR+LF
None
NT Link (1:N
0 to 7
NT Link (1:N
0 to 7
mode)
Standard NT
Link
mode)
Standard NT
Link
Setting
contents
Settings
Time
Host Link
Standard NT
Link
0
Host Link
Standard NT
Link
0
Host Link
0 ms
00 hex
00 hex
256 bytes
Received bytes
None
Default
Default
Turn ON pin 2
on the Coordi-
nator Module
DIP switch.
---
---
---
Section 6-1
conditions
Each cycle
Other
Enabled