XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 119

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

Module Wiring
3-2
3-2-1
92
AC power supply
100 to 240 V
Module Wiring
Wiring Power Supply Units
transformer 1:1
(4) A 63-mm hole will be required if the I/O Connecting Cable must pass
(5) The cables can withstand a pulling force up to 49 N (11 lbs), so be sure
(6) The I/O Connecting Cables mustn’t be bent too severely. The minimum
(7) Always attach the cover to the output connector (left side) on the I/O In-
OFF when in PROGRAM mode
is in RUN or MONITOR mode.
ON when Coordinator Module
Isolation
through a hole when connecting an Expansion Rack.
that they aren’t pulled too forcefully.
bending radii are shown in the following diagram.
terface Unit on the Expansion Rack to protect it from dust.
RUN output (See note.)
or during a fatal error.
AC power supply
R
Output connector cover
R
Note: Cable diameter: 8.6 mm
CJ1W-II101
I/O Interface Unit
M4 self-raising screws
Power
supply
II101
OU T
69 mm
IN
PA202
AC100
INPUT
-240V
L2/N
NC
NC
L1
POWER
Section 3-2