XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 38

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

1-5
1-5-1
System Configuration
Expanded System Configuration
Expanded System Configuration
Serial Communications
The following table lists the Programming Devices other than the CX-Pro-
grammer that can be used with CJ-series Units.
The FQM1 system can be expanded using the two serial ports built into the
Coordinator Module: Peripheral port and RS-232C port.
CX-Designer
NS-Designer
CX-Motion-NCF The CX-Motion-NCF can be used to set CJ1W-
CX-Integrator
CX-Drive
SPU-Console
Programming
Host Link
Device
Host computer
RS-232C port
Peripheral
port
These are Programming Devices for HMI devices.
Can be connected through the Coordinator Module’s
communications port or directly connected to PT.
NCF71 Position Control Units and connected Servo
Drivers. Connect through the Coordinator Module’s
communications port.
The CX-Integrator is network configuration support
software, which cannot be used through the Coordi-
nator Module’s communications port.
DeviceNet settings for DeviceNet Slave Units in the
FQM1 can be made through the DeviceNet Master
Unit mounted to the host PLC. The Configurator can
be connected to the Coordinator Module’s communi-
cations port.
Use the CX-Motion-NCF to change parameters in
Servo Drivers connected to a CJ1W-NCF71 Position
Control Unit.
The SPU-Console can be used to set and operate
SYSMAC SPU Units. Connect this Programming
Device directly to the SPU Unit.
CX-Programmer
Coordinator Module
Automatic detection of
communications parameters
Description
Section 1-5
Connection
Supported
Supported
Not sup-
ported
Not sup-
ported
Supported
11