XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 432

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

When the Unit’s settings are changed, they are stored in A220 to A259 (Actual Input Response Times for Basic
I/O Units). When the settings in the System Setup have been changed with the FQM1 in PROGRAM mode, the
System Setup settings will differ from the actual settings in the Units. In this case, the values in A220 to A259
can be monitor to see the input response times actually in the Units.
Startup Mode
This setting determines the operating mode that will be used when the power supply to the Coordinator Module
is turned ON.
Note The Coordinator Module will start in RUN mode unless the Startup Mode setting in the System Setup is
Peripheral Port Settings
The standard settings are for Host Link Mode, 1 start bit, 7-bit data, even parity, 2 stop bits, and 9,600 baud.
Change the System Setup if any other settings are required.
RS-232C Port Settings (Host Link Port)
The standard settings are for Host Link Mode, 1 start bit, 7-bit data, even parity, 2 stop bits, and 9,600 baud.
Change the System Setup if any other settings are required. If no-protocol communications are to be used, be
sure to change the frame format.
Note The RS-232C port settings can also be changed with the STUP (237) instruction. The RS-232C Port
Note The following data is set for no-protocol mode.
System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations
System Setup mode setting disabled
System Setup mode setting enabled
enabled.
Settings Changing Flag (A619.01) will remain ON from the time STUP (237) is executed until the set-
tings have actually been changed.
FLEXIBLE
MOTION
CONTROLLER
TXD(236)
PERIPHERAL
PORT
Send delay
COMM1
COMM2
PRPHL
RDY
RUN
ERR
39
1
ON
CM001
OFF
2
RS422
40
CN1
Data sent
RS-232C Port Settings
The standard (default) settings are as follows:
Host Link Mode
1 start bit
7-bit data
Even parity
2 stop bits
9,600 baud rate
If any other serial communications mode is
being used (e.g., NT Link, no-protocol,
peripheral bus, or Host Link), change the
baud rate or other settings as required.
RUN mode
Program: PROGRAM mode
Monitor: MONITOR mode
Run:
Time
RUN mode
Appendix C
405