XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 251

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

Pulse Outputs
7-6-4
All Pulse Outputs Except for One-shot Pulse Outputs
One-shot Pulse Outputs
224
Number of output
pulses
Storage location for
pulse output PV
Item
Pulse Output Specifications
1) Relative pulse output:
2) Absolute linear pulse output:
3) Absolute circular pulse output:
4) Electronic cam control (linear) (output with absolute position specification):
5) Electronic cam control (circular) (output with absolute position specification):
Note The number of pulses is not set for a one-shot pulse output or pulse counter timer.
The PVs for pulse output operation modes 1 to 5, listed above, are stored in 8-digit hexadecimal
in the following Auxiliary Area words:
Pulse output 1: A871 (upper bytes) and A870 (lower bytes)
Pulse output 2: A873 (upper bytes) and A872 (lower bytes)
Target value comparison interrupts or bit pattern outputs for range comparisons can be per-
formed on the PV.
Note The contents of these above words are updated during I/O refreshing.
Number of pulse out-
puts
Signals
Max. output fre-
quency
External power sup-
ply
Line-driver output
Number of pulse out-
puts
External power sup-
ply
Max. switching
capacity
Min. switching
capacity
Leakage current
Residual voltage
Output pulse width
Item
Item
2 outputs
Pulse output CW and CCW
1 MHz (but actual output frequencies are governed by clock
frequency setting)
5 VDC +10%/–15%, 120 mA max.
Conforms to Am26LS31 and max. output current is 20 mA.
2 output
24 VDC +10%/–15%, 30 mA max.
NPN open-collector, 80 mA at 5 to 24 VDC 10%
NPN open-collector, 7 mA at 5 to 24 VDC 10%
0.1 mA max.
0.4 V max.
(Set time)
Note
1. The load during measurement is assumed to be a simple re-
2. The actual pulse width might be smaller than the value given
ON
OFF
sistive load and the impedance of the cable connecting the
load is not considered.
above due to pulse waveform distortion caused by imped-
ance in the connecting cables.
Specification
0000 0000 to FFFF FFFF hex
8000 0000 to 7FFF FFFF hex
0000 0000 to Circular maximum count hex
8000 0000 to 7FFF FFFF hex
0000 0000 to 7FFF FFFF hex
(1 s or 0.1% of the set time, whichever is larger)
pulse width
Output
Specification
Specification
90%
Section 7-6