XW2Z-200J-B9 Omron, XW2Z-200J-B9 Datasheet - Page 427

• Manufacturer Part Number: XW2Z-200J-B9
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB9

CX-Programmer: Cycle Time Tab Page
CX-Programmer: Other Tab Page
These settings are reserved for future expansion of Motion Control Module functionality.
400
System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations
+305
+306
+307
+308
Address
Address
00 to 03 Interrupt Input Settings, Input 0 (CIO
04 to 07 Interrupt Input Settings, Input 1 (CIO
08 to 11 Interrupt Input Settings, Input 2 (CIO
12 to 15 Interrupt Input Settings, Input 3 (CIO
00 to 07 Select Synchro-
08 to 15
00 to 15 Cycle time
00 to 15 Watch cycle time
Bits
Bits
0000.00) function
0000.01) function
0000.02) function
0000.03) function
nous Data
Function
Function
Upper 2 words (+0
and +1)
Lower 2 words (+2
and +3)
0 hex: Normal
1 hex: Interrupt input (at rising edge)
2 hex: Interrupt input (at falling edge)
3 hex: Interrupt input (at both edges)
Note Interrupt input settings of 1 to 3 hex
00 hex: Normal (via Ladder)
01 hex: High-speed counter PV (Counter 1 val-
ues)
02 hex: High-speed counter PV (Counter 2 val-
ues)
03 hex: Pulse output 1 PV
04 hex: Pulse output 2 PV
05 hex: Analog input
06 hex: Reserved
07 hex: Analog output 1 value
08 hex: Analog output 2 value
09 hex: Built-in input value (Inner I/O input)
5A hex: No data
0000 hex: Variable cycle time
0001 to 03E8 hex: Constant (minimum) cycle
time of 0.1 to 100.0 ms (unit: 0.1 ms)
If the actual cycle time is less than this setting,
it will be extended until this time passes.
Note A316.05 will turn ON if the minimum
Change this setting only when you want to
change the default maximum cycle time. The
Cycle Time Too Long Flag (A401.08) will be
turned ON if the actual cycle time exceeds this
setting.
apply to input interrupt mode and
counter mode.
cycle time set here is exceeded.
Remarks
Remarks
At power ON
At start of operation
At start of operation
When setting is read
When setting is read
Appendix C