MPC8544DS Freescale Semiconductor, MPC8544DS Datasheet - Page 668

• Manufacturer Part Number: MPC8544DS
• Description: BOARD DEVELOPMENT SYSTEM 8544
• Manufacturer: Freescale Semiconductor
• Series: PowerQUICC III™r
• Type: MPUr

Specifications of MPC8544DS

• Contents: Board
• Processor To Be Evaluated: MPC8544E
• Data Bus Width: 32 bit
• Interface Type: Ethernet, I2C
• Operating Supply Voltage: - 0.3 V to + 1.1 V
• Leaded Process Compatible: Yes
• Peak Reflow Compatible (260 C): Yes
• Rohs Compliant: Yes
• For Use With/related Products: MPC8544
• For Use With: PPC8544EVTANG - EVAL MPC8544 783FCPBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Local Bus Controller
14.4.3.2
Following a system reset, initialization software must set up the programmable parameters in the memory
controller banks registers (ORn, BRn, LSDMR). After all memory parameters are configured, system
software should execute the following initialization sequence for each SDRAM device.
The initial commands are executed by setting LSDMR[OP] and accessing the SDRAM with any write that
hits the relevant bank. Since the result of any update to the LSDMR must be in effect before accessing the
SDRAM with any write, a write to LSDMR should be followed immediately by a read from LSDMR,
which must complete prior to an initial write to SDRAM. Further, the first write to SDRAM should be
followed immediately by an SDRAM read, which must complete prior to additional LSDMR updates. This
enforces a proper ordering between updates to the LSDMR and write accesses to the SDRAM. If the
initialization is being done by the e500, this described protocol is guaranteed only if the SDRAM is
mapped as cache-inhibited and guarded, as the CCSR memory region containing LSDMR should be. If the
initialization is from an external host, said host must ensure completion of LSDMR and SDRAM reads
prior to subsequent writes, as described above.
Note that software should ensure that no memory operations begin until this process completes.
14-48
•
•
•
Issue a PRECHARGE-ALL-BANKS command
Issue eight AUTO-REFRESH commands
Issue a MODE-SET command to initialize the mode register
MPC8544E PowerQUICC III Integrated Host Processor Family Reference Manual, Rev. 1
SDRAM Power-On Initialization
Local Bus
Controller
Figure 14-34. Connection to a 32-Bit SDRAM with 12 Address Lines
LSDDQM[0:3]
LAD[0:31]
LA[27:29]
LSDRAS
LSDCAS
LSDA10
LSDWE
LCLK
LCKE
LCS1
LALE
LAD[18,20:26]
Memory Address
Memory Data
A[11,9:3]
WE
RAS
CAS
CS
DQM[3:0]
A10
A[2:0]
DQ[31:0]
CLK
CKE
32-Bit Port Size
SDRAM
Freescale Semiconductor