IPR-XAUIPCS Altera, IPR-XAUIPCS Datasheet - Page 58

no-image

IPR-XAUIPCS

Manufacturer Part Number
IPR-XAUIPCS
Description
IP CORE Renewal Of IP-XAUIPCS
Manufacturer
Altera
Datasheet

Specifications of IPR-XAUIPCS

Software Application
IP CORE, Interface And Protocols, ETHERNET
Supported Families
Stratix IV GT, Stratix V
Features
10Gbase-R PHY IP Core, Xaui PHY IP Core, Memory-Mapped (Avalon-Mm) Interface
Core Architecture
FPGA
Core Sub-architecture
Stratix
Rohs Compliant
NA
Lead Free Status / RoHS Status
na
5–6
Table 5–6. Avalon-MM PCS Management Interface
Table 5–7. Interlaken Registers (Part 1 of 3)
Altera Transceiver PHY IP Core User Guide
phy_mgmt_clk
phy_mgmt_clk_reset
phy_mgmt_addr[8:0]
phy_mgmt_writedata[31:0]
phy_mgmt_readdata[31:0]
phy_mgmt_write
phy_mgmt_read
phy_mgmt_waitrequest
0x022
0x041
0x042
Word
Addr
Avalon Memory-Mapped (Avalon-MM) Management Interface
[31:0]
[31:0]
Signal Name
[1:0]
Bits
The Avalon-MM PHY management block includes master and slave interfaces. This
component acts as a bridge. It transfers commands received on its Avalon-MM slave
interface to its Avalon-MM port. This interface manages PCS and PMA modules,
resets, error handling, and serial loopback controls.
that comprise the Avalon-MM PCS management interface.
Register Descriptions
Table 5–7
management interface using word addresses and a 32-bit embedded processor. A
single address space provides access to all registers.
R/W
RW
W
R
R
pma_tx_pll_is_locked
reset_ch_bitmask
reset_control (write)
reset_status(read)
specifies the registers that you can access using the Avalon-MM PHY
Register Name
PMA Common Control and Status Registers
Direction
Output
Output
Input
Input
Input
Input
Input
Input
Reset Control Registers
Avalon-MM clock input.
Global reset signal that resets the entire interlaken PHY. A positive
edge on this signal triggers the reset controller.
9-bit Avalon-MM address.
Input data.
Output data.
Write signal.
Read signal.
When asserted, indicates that the Avalon-MM slave interface is unable
to respond to a read or write request. When asserted, control signals
to the Avalon-MM slave interface must remain constant.
Bit[P] indicates that the TX/CMU PLL (P) is locked to the
input reference clock. There is typically one
pma_tx_pll_is_locked bit per system.
Reset controller channel bitmask for digital resets. The
default value is all 1s. Channel <n> can be reset when
<n> = 1.
Writing a 1 to bit 0 initiates a TX digital reset using the reset
controller module. The reset affects channels enabled in the
reset_ch_bitmask. Writing a 1 to bit 1 initiates a RX
digital reset of channels enabled in the
reset_ch_bitmask.
Reading bit 0 returns the status of the reset controller TX
ready bit. Reading bit 1 returns the status of the reset
controller RX ready bit.
Description
Table 5–6
Description
December 2010 Altera Corporation
Chapter 5: Interlaken PHY IP Core
describes the signals
Interface

Related parts for IPR-XAUIPCS