NH82801HBM S LB9A Intel, NH82801HBM S LB9A Datasheet - Page 204

• Manufacturer Part Number: NH82801HBM S LB9A
• Description: CONTROLLER HUB, ICH8M, I/O, 82801HBM
• Manufacturer: Intel

Specifications of NH82801HBM S LB9A

• Power Dissipation Pd: 2.4W
• Digital Ic Case Style: BGA
• No. Of Pins: 676
• Pci Bus Type: I/O Controller Hub
• Pci Express Base Spec: PCIe 1.1
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.17.3
5.17.4
204
Periodic vs. Non-Periodic Modes
Non-Periodic Mode
Timer 0 is configurable to 32 (default) or 64-bit mode, whereas Timers 1 and 2 only
support 32-bit mode (See
All three timers support non-periodic mode.
Consult Section 2.3.9.2.1 of the IA-PC HPET Specification for a description of this
mode.
Periodic Mode
Timer 0 is the only timer that supports periodic mode. Consult Section 2.3.9.2.2 of the
IA-PC HPET Specification for a description of this mode.
The following usage model is expected:
The Timer 0 Comparator Value register cannot be programmed reliably by a single 64-
bit write in a 32-bit environment except if only the periodic rate is being changed
during run-time. If the actual Timer 0 Comparator Value needs to be reinitialized, then
the following software solution will always work regardless of the environment:
Enabling the Timers
The BIOS or operating system PnP code should route the interrupts. This includes the
Legacy Rout bit, Interrupt Rout bit (for each timer), interrupt type (to select the edge
or level type for each timer)
The Device Driver code should do the following for an available timer:
1. Software clears the ENABLE_CNF bit to prevent any interrupts
2. Software Clears the main counter by writing a value of 00h to it.
3. Software sets the TIMER0_VAL_SET_CNF bit.
4. Software writes the new value in the TIMER0_COMPARATOR_VAL register
5. Software sets the ENABLE_CNF bit to enable interrupts.
1. Set TIMER0_VAL_SET_CNF bit
2. Set the lower 32 bits of the Timer0 Comparator Value register
3. Set TIMER0_VAL_SET_CNF bit
4. 4) Set the upper 32 bits of the Timer0 Comparator Value register
1. Set the Overall Enable bit (Offset 04h, bit 0).
2. Set the timer type field (selects one-shot or periodic).
3. Set the interrupt enable
4. Set the comparator value
Section
19.1.5).
Intel
®
Functional Description
ICH8 Family Datasheet