D6417729RHF200BV Renesas Electronics America, D6417729RHF200BV Datasheet - Page 599

• Manufacturer Part Number: D6417729RHF200BV
• Description: IC SUPER H MPU ROMLESS 208QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of D6417729RHF200BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.85 V ~ 2.15 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-QFP Exposed Pad, 208-eQFP, 208-HQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Switching Modes: When switching from receive mode to transmit mode, check that the receive
operation is completed before starting initialization, clearing RE to 0, and setting TE to 1. The
RDRF, PER, and ORER flags can be used to check if reception is completed. When switching
from transmit mode to receive mode, check that the transmit operation is completed before starting
initialization, clearing TE to 0, and setting RE to 1. The TEND flag can be used to check if
transmission is completed.
Interrupt Operation: In the smart card interface mode, there are three types of interrupts:
transmit-data-empty (TXI), communication error (ERI) and receive-data-full (RXI). In this mode,
the transmit-end interrupt (TEI) cannot be requested.
Set the TEND flag in SCSSR to 1 to request a TXI interrupt. Set the RDRF flag in SCSSR to 1 to
request an RXI interrupt. Set the ORER, PER, or FER/ERS flag in SCSSR to 1 to request an ERI
interrupt (table 16.9).
Table 16.9 Smart Card Mode Operating State and Interrupt Sources
Mode
Transmit mode
Receive mode
16.4
When the SCI is used as a smart card interface, be sure that all criteria in sections 16.4.1, Receive
Data Timing and Receive Margin in Asynchronous Mode and 16.4.2, Retransmission (Receive
and Transmit Modes) are applied.
16.4.1
In asynchronous mode, the SCI runs on a base clock with a frequency of 372 times the transfer
rate. During reception, the SCI samples the falling of the start bit using the base clock to achieve
internal synchronization. Receive data is latched internally at the rising edge of the 186th base
clock cycle (figure 16.8).
Usage Notes
Receive Data Timing and Receive Margin in Asynchronous Mode
State
Normal
Error
Normal
Error
Flag
TEND
FER/ERS
RDRF
PER,
ORER
Mask Bit
TIE
RIE
RIE
RIE
Rev. 5.0, 09/03, page 551 of 806
Interrupt Source
TXI
ERI
RXI
ERI