D6417729RHF200BV Renesas Electronics America, D6417729RHF200BV Datasheet - Page 187

• Manufacturer Part Number: D6417729RHF200BV
• Description: IC SUPER H MPU ROMLESS 208QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of D6417729RHF200BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.85 V ~ 2.15 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-QFP Exposed Pad, 208-eQFP, 208-HQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

4. PINT Pin Interrupts
5. On-Chip Peripheral Interrupts
6. UDI Interrupt
Conditions: The PINT pin is asserted, the interrupt mask bits in SR are lower than the
PINT priority level, and the BL bit in SR is 0. The interrupt is accepted at an instruction
boundary.
Operations: The PC value after the instruction at which the interrupt is accepted is saved to
SPC. SR at the point the interrupt is accepted is saved to SSR. The code corresponding to
the interrupt source is set in INTEVT and INTEVT2. The BL, MD, and RB bits of SR are
set to 1 and a branch occurs to VBR + H'0600. The received level is not set in the interrupt
mask bits in SR. See section 7, Interrupt Controller (INTC), for more information.
Conditions: The interrupt mask bits in SR are lower than the on-chip module (TMU, RTC,
SCI, IrDA, SCIF, A/D, DMAC, WDT, REF) interrupt level and the BL bit in SR is 0. The
interrupt is accepted at an instruction boundary.
Operations: The PC value after the instruction at which the interrupt is accepted is saved to
SPC. SR at the point the interrupt is accepted is saved to SSR.The code corresponding to
the interrupt source is set in INTEVT and INTEVT2. The BL, MD, and RB bits in SR are
set to 1 and a branch occurs to VBR + H'0600. See section 7, Interrupt Controller (INTC),
for more information.
Conditions: An UDI interrupt command is input (see section 23.4.4, UDI Interrupt),
SR.IMASK is lower than 15, and the BL bit in SR is 0. The interrupt is accepted at an
instruction boundary.
Operations: The PC value after the instruction that accepts the interrupt is saved to SPC.
SR at the point the interrupt is accepted is saved to SSR. H'5E0 is set to INTEVT and
INTEVT2. The BL, MD, and RB bits in SR are set to 1 and a branch occurs to VBR +
H'0600. See section 7, Interrupt Controller (INTC), for more information.
Rev. 5.0, 09/03, page 139 of 806