EZ80F91MCU ZILOG [Zilog, Inc.], EZ80F91MCU Datasheet - Page 229

• Manufacturer Part Number: EZ80F91MCU
• Description: eZ80Acclaim-TM Flash Microcontrollers
• Manufacturer: ZILOG [Zilog, Inc.]

PS019209-0504
SPI Signals
The four basic SPI signals are:
•
•
•
•
These SPI signals are discussed in the following paragraphs. Each signal is
described in both MASTER and SLAVE modes.
Master In, Slave Out
The Master In, Slave Out (MISO) pin is configured as an input in a master device
and as an output in a slave device. It is one of the two lines that transfer serial
data, with the most-significant bit sent first. The MISO pin of a slave device is
placed in a high-impedance state if the slave is not selected. When the SPI is not
enabled, this signal is in a high-impedance state.
Master Out, Slave In
The Master Out, Slave In (MOSI) pin is configured as an output in a master device
and as an input in a slave device. It is one of the two lines that transfer serial data,
with the most-significant bit sent first. When the SPI is not enabled, this signal is in
a high-impedance state.
Slave Select
The active Low Slave Select (SS) input signal is used to select the SPI as a slave
device. It must be Low prior to all data communication and must stay Low for the
duration of the data transfer.
The SS input signal must be High for the SPI to operate as a master device. If the
SS signal goes Low, a Mode Fault error flag (MODF) is set in the SPI_SR register.
See the
When the Clock Phase (CPHA) is set to 0, the shift clock is the logical OR of SS
with SCK. In this clock phase mode, SS must go High between successive char-
acters in an SPI message. When CPHA is set to 1, SS can remain Low for several
SPI characters. In cases where there is only one SPI slave, its SS line could be
tied Low as long as CPHA is set to 1. See the
page 216 for more information on CPHA.
Serial Clock
The Serial Clock (SCK) is used to synchronize data movement both in and out of
the device via its MOSI and MISO pins. The master and slave are each capable of
MISO (Master In, Slave Out)
MOSI (Master Out, Slave In)
SCK (SPI Serial Clock)
SS (Slave Select)
SPI Status Register
P R E L I M I N A R Y
(SPI_SR) on page 217 for more information.
SPI Control Register
Product Specification
Serial Peripheral Interface
eZ80F91 MCU
(SPI_CTL) on
210