DF2170VTE33 Renesas Electronics America, DF2170VTE33 Datasheet - Page 448

• Manufacturer Part Number: DF2170VTE33
• Description: MCU 3V 256K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2170VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: SCI, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 76
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: HD64F2170VTE33; HD64F2170VTE33

Erasing and Programming Procedure in User Program Mode: By changing the on-chip RAM
address of the download destination in FTDAR, the erasing program and programming program
can be downloaded to separate on-chip RAM areas.
Figure 14.13 shows a repeating procedure of erasing and programming.
In the above procedure, download and initialization are performed only once at the beginning.
In this kind of operation, note the following:
Rev. 2.00, 03/04, page 414 of 534
 Be careful not to damage on-chip RAM with overlapped settings.
 Be sure to initialize both the erasing program and programming program.
In addition to the erasing program area and programming program area, areas for the user
procedure programs, work area, and stack area are reserved in on-chip RAM. Do not make
settings that will overwrite data in these areas.
Initialization by setting the FPEFEQ parameter must be performed for both the erasing
program and the programming program. Initialization must be executed for both entry
addresses: (download start address for erasing program) + 32 bytes and (download start
address for programming program) + 32 bytes.
destination of programming
Download erasing program
Figure 14.13 Repeating Procedure of Erasing and Programming
Initialize erasing program
Start procedure program
Download programming
Initialize programming
destination of erasing
Specify a download
program by FTDAR
Specify a download
program by FTDAR
program
program
1
(execute erasing program)
End procedure program
(execute programming
program relevant block
Erase relevant block
Confirm operation
Set FMPDR to
program)
End ?
1
Yes
No