DF2170VTE33 Renesas Electronics America, DF2170VTE33 Datasheet - Page 185

• Manufacturer Part Number: DF2170VTE33
• Description: MCU 3V 256K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2170VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: SCI, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 76
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: HD64F2170VTE33; HD64F2170VTE33

6.9
This LSI has a bus arbiter that arbitrates bus master operations (bus arbitration).
There are two bus mastersthe CPU and DMACthat perform read/write operations when they
have possession of the bus. Each bus master requests the bus by means of a bus request signal. The
bus arbiter determines priorities at the prescribed timing, and permits use of the bus by means of a
bus request acknowledge signal. The selected bus master then takes possession of the bus and
begins its operation.
6.9.1
The bus arbiter detects the bus masters’ bus request signals, and if the bus is requested, sends a bus
request acknowledge signal to the bus master. If there are bus requests from more than one bus
master, the bus request acknowledge signal is sent to the one with the highest priority. When a bus
master receives the bus request acknowledge signal, it takes possession of the bus until that signal
is canceled.
The order of priority of the bus master is as follows:
6.9.2
Even if a bus request is received from a bus master with a higher priority than that of the bus
master that has acquired the bus and is currently operating, the bus is not necessarily transferred
immediately. There are specific timings at which each bus master can relinquish the bus.
CPU: The CPU is the lowest-priority bus master, and if a bus request is received from the DMAC,
the bus arbiter transfers the bus to the bus master that issued the request. The timing for transfer of
the bus is as follows:
• The bus is transferred at a break between bus cycles. However, if a bus cycle is executed in
• With bit manipulation instructions such as BSET and BCLR, the sequence of operations is:
• If the CPU is in sleep mode, the bus is transferred immediately.
discrete operations, as in the case of a longword-size access, the bus is not transferred between
the component operations.
data read (read), relevant bit manipulation operation (modify), write-back (write). The bus is
not transferred during this read-modify-write cycle, which is executed as a series of bus cycles.
(High) DMAC > CPU (Low)
Bus Arbitration
Operation
Bus Transfer Timing
Rev. 2.00, 03/04, page 151 of 534