r5s72060w200fpv Renesas Electronics Corporation., r5s72060w200fpv Datasheet - Page 1020

• Manufacturer Part Number: r5s72060w200fpv
• Description: 32-bit Risc Microcomputer Superhtm Risc Engine Family / Sh7200 Series
• Manufacturer: Renesas Electronics Corporation.

Section 23 High-Performance User Debugging Interface (H-UDI)
23.5
1. An H-UDI command, once set, will not be modified as long as another command is not set
2. In software standby mode and H-UDI module standby state, all of the functions in the H-UDI
3. Regardless of whether the H-UDI is used, make sure to keep the TRST pin low at power-on to
4. Make sure to put 20 t
5. When starting the TAP controller after the negation of the TRST pin, make sure to allow 200
Rev. 2.00 Dec. 09, 2005 Page 996 of 1152
REJ09B0191-0200
again from the H-UDI. If the same command is to be set continuously, the command must be
set after a command (BYPASS mode, etc.) that does not affect chip operations is once set.
cannot be used. To retain the TAP status before and after standby mode, keep TCK high before
entering standby mode.
initialize the H-UDI.
ns or more after the negation.
Usage Notes
cyc
or more between the signal change timing of the RES and TRST pins.