HD6417712BPV Renesas Electronics America, HD6417712BPV Datasheet - Page 850

• Manufacturer Part Number: HD6417712BPV
• Description: MPU 1.5/3.3V 0K PB-FREE 256-BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH Ethernetr

Specifications of HD6417712BPV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: EBI/EMI, Ethernet, FIFO, SCI, SIO
• Peripherals: DMA, POR, WDT
• Number Of I /o: 24
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

Section 22 User Debugging Interface (H-UDI)
Data loaded into the output pin boundary scan register in the Capture-DR state is not used for
external circuit testing (it is replaced by a shift operation).
The upper four bits of the instruction code are B'0000.
IDCODE: A command can be set in SDIR by the H-UDI pins to place the H-UDI pins in the
IDCODE mode stipulated by JTAG. When the H-UDI is initialized (TRST is asserted or TAP is in
the Test-Logic-Reset state), the IDCODE mode is entered.
CLAMP, HIGHZ: A command can be set in SDIR by the H-UDI pins to place the H-UDI pins in
the CLAMP or HIGHZ mode stipulated by JTAG.
22.5.2
1. Boundary scan mode does not cover clock-related signals (EXTAL, EXTAL2, XTAL,
2. Boundary scan mode does not cover reset-related signals (RESETP, RESETM).
3. Boundary scan mode does not cover H-UDI-related signals (TCK, TDI, TDO, TMS, TRST).
4. Boundary scan mode does not cover the ASEMD0 pin.
5. When the EXTEST, CLAMP, and HIGHZ commands are set, fix the RESETP pin low.
6. When a boundary scan test for other than BYPASS and IDCODE is carried out, fix the
22.6
1. An H-UDI command, once set, will not be modified as long as another command is not re-
2. In standby mode, the H-UDI function cannot be used. To retain the TAP status before and
3. The H-UDI is used for emulator connection. Therefore, H-UDI functions cannot be used when
22.7
The AUD is a function only for an emulator. For details on the AUD, refer to each emulator’s
user’s manual.
Rev. 1.00 Dec. 27, 2005 Page 806 of 932
REJ09B0269-0100
XTAL2, CKIO, CKIO2).
ASEMD0 pin high.
issued from the H-UDI. If the same command is given continuously, the command must be set
after a command (BYPASS, etc.) that does not affect chip operations is once set.
after standby mode, keep TCK high before entering standby mode.
using an emulator.
Points for Attention
Usage Notes
Advanced User Debugger (AUD)