TMPA901CMXBG Toshiba, TMPA901CMXBG Datasheet - Page 508

• Manufacturer Part Number: TMPA901CMXBG
• Description: Microcontrollers (MCU) 32-bit RISC MCU 16kb ARM926EJ 16kb 200Mhz
• Manufacturer: Toshiba

Specifications of TMPA901CMXBG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): -
• Rom Type: ROMless
• Ram (kbytes): 32
• Number Of Pins: 177
• Package: BGA
• Vcc: 3V
• Tft Lcd Controller: Y
• Touchscreen Controller: Y
• Usb Host Fs With Phy: Y
• Usb Device Hs With Phy: Y
• Sd Host Controller: -
• Cmos Image Sensor Interface: -
• I2s: 1
• Ssp (ch) Spi: 1
• I2mc/sio (ch): 1
• Uart/sio (ch): 2
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 8
• 10-bit Ad Converter: 4
• 12-bit Da Converter: -
• 16-bit Timer / Counter: 6
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Low-power Modes: Y
• Lead Free Status / Rohs Status: Details

b. <ep_bi_mode>
c.
d. <suspend>
e. <configured>, <addressed>, <default>
f.
Selects whether to use the endpoint bidirectionally as a driver.
Setting this bit to 1 will enable an endpoint number to be used bidirectionally in USB
communication.
0y0: Single direction
0y1: Dual direction
<cur_speed[1:0]>
Indicates the present transfer mode on the USB bus.
0y00: Reserved
0y01: Full-Speed
0y10: High-Speed
0y11: Reserved
Indicates whether or not UDC2 is in suspended state.
0y0: Normal
0y1: Suspended
Set the present device state of UDC2. This should be set in accordance with the request
received from the host. Please note that you should not set 1 to more than one bit.
<dev_adr[6:0]>
Sets the device address assigned by the host.
The device address should be set after Set_address has finished normally (after
STATUS-Stage finished normally).
0y001: default (to be set when the DeviceAddress = 0 was specified by the Set_address
0y010: addressed (to be set when ConfigurationVallue = 0 was specified by the
0y100: configured (to be set when the Set_config request is received)
request in Default/Address state (this will be set by the hardware when
USB_RESET is received))
Set_configuration request after the Set_address request finished normally and
in the Address/Configured state)
TMPA901CM- 507
TMPA901CM
2010-07-29