DF38602RFT10 Renesas Electronics America, DF38602RFT10 Datasheet - Page 530

• Manufacturer Part Number: DF38602RFT10
• Description: MCU 3V 16K 32-QFN
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H SLPr

Specifications of DF38602RFT10

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: I²C, IrDA, SCI, SSU
• Peripherals: POR, PWM, WDT
• Number Of I /o: 13
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 32-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F38602RFT10; HD64F38602RFT10

Rev. 3.00 May 15, 2007 Page 496 of 516
REJ09B0152-0300
Item
Section 4 Clock Pulse Generators
4.2.4 On-Chip Oscillator Selection
Method
Figure 4.5 Typical Connection to
32.768-kHz/38.4-kHz Crystal
Resonator
4.3.1 Connecting 32.768-
kHz/38.4-kHz Crystal Resonator
4.4.1 Prescaler S
Page Revisions (See Manual for Details)
67
68
68
71
Modified
…… The input level on the E7_2 pin during a reset is
pulled up or down using a resistor according to the
selected oscillator, and fixed on exit from the reset
state.
When the on-chip oscillator is selected, a resonator no
longer needs to be connected to the OSC1 and OSC2
pins. In such a case, fix the OSC1 pin to GND or leave
it open, and leave the OSC2 pin open.
Note is added.
Notes:
1. ……
2. When the on-chip debugger is connected, the value
Modified
Added
1. When the resonator other than ones listed above is
2. Perform matching evaluation in the reset state (the
Deleted
The output from prescaler S is shared by the on-chip
peripheral modules. The division ratio can be set
separately for each on-chip peripheral function.
Note: Consult with the crystal resonator manufacturer to determine the parameters.
C = C
Frequency
38.4 kHz
32.768 kHz
1
used, perform matching evaluation with the crystal
resonator manufacture and connect it under the
optimum condition. Even when the resonator listed
above or the equivalent is used, as the oscillation
characteristics depend on the board specification,
perform matching evaluation on the mounting board.
RES pin is low) and on exit from the reset state (the
RES pin is driven from low to high).
of the resistor should be high. When not connected,
it is specified according to the selected oscillator.
2
= 7 pF (typ.)
Manufacturer
EPSON TOYOCOM CORPORATION
EPSON TOYOCOM CORPORATION
Products Name
C-4-TYPE
C-001R
Equivalent Series Resistance
30 kΩ (max.)
35 kΩ (max.)